Connectors 30ML Spillage Test Apparatus IEC60335-2-15 With Spillage Prtoection
|
IEC60335-2-15 30ML Spillage Test Apparatus for Testing the Connectors with Spillage Prtoection
1. Introduction: The spillage test apparatus meets the requirements of IEC60335-2-15 clause 15.2 and figure 101. It’s used to check the connectors with spillage protection to ensure that the connectors are not affected by liquids when installed in a rated voltage base according to the manufacturer’s installation instructions.
the spillage test is carried out with the appliance deviating from the normal position of use by an angle not exceeding 5°. The kettles are placed on a plane inclined at an angle of 20° to the horizontal and 30ml of water containing approximately 1% NACL is poured onto the top rim in the most unfavourable place. The solution is poured steadily through a tube having an inner diameter of 8mm over a period of 2s, the lower end of the tube being 200mm above the appliance. A further quantity, equal to 15% of the rated capacity of the kettel, is then added as quickly as possible.
2. Parameters:
3. Drawings
|
||||||||||
Product Tags: Connectors Spillage Test Apparatus 30ML Spillage Test Apparatus Spillage Prtoection Spillage Test Equipment |
IEC62368-1 Steel Disc Aluminum Ring Aluminum Foil for Temperature Rising Test |
Brass Electrodes Dielectric Strength Tester UL1310 12KV For Insulating Material |
IEC60065 Electrical Safety Test Equipment Thin Layer Insulation Material Dielectric Strength Test |
UL1310 Dielectric Strength Test Equipment For Thin Layer Insulation Material |
ISO6722-1 Motor-Driven Scrape Abrasion Test Apparatus for Testing Auto Cables |
80mm Blunt Probe As Per IEC 60950 IEC 60065 IEC 62368-1 For Testing TNT Circuit |