Automobile Wheel Hub Cationic Electrophoretic Coating

Automobile Wheel Hub Cationic Electrophoretic Coating

Product Introduction

HLS-1701ALB/HLS-1701A Black Cationic Epoxy Electrocoat for auto is a new generation electrophoretic coating researched and developed by HLS Paint (Shanghai) Co., Ltd.

It represents modern technology of cathodic electrophoretic coating that is environment-friendly with high property and low cost. Such coating does not contain heavy metal like lead, tin, cadmium and mercury etc. It is a two-component, water-dispersed resin,meanwhile, it took in features of previous products, and can adapt galvanized steel sheet perfectly, almost can be applied to foundation coating of all metal, such as: cold and hot rolled steel sheet, galvanized steel sheet, aluminum products and stainless steel sheet etc.

 
This product features shown below:

Main ingredients
 

Filling tank proportion and method
 
⑴ Ripening conditions
Sample quantity: 3000～5000g
Container: 4L (Diameter 16cm)
Tank temperature: 28-30 ℃
Time: 24～48Hr
Mixed conditions: impeller diameter 8cm (speed 200rpm)

Storage, packaging and transportation ​:
 
This product is a water-borne industrial coatings, non-hazardous, non-inflammable and explosive products; transportation to prevent direct sunlight, avoid freezing (>5℃ ); Packaging for 50/60/200L Plastic barrel; in the transport and storage of drums should be maintained clean, avoid charging the dirt brought in on drums during filling tank, again checked and confirmed that the quality of products, including paste resin, emulsions and additives should be indoor storage, good ventilation, dry, protect against freezing and overheating, the storage temperature should be controlled at 5～35℃, products from the date of production, over shelf, experimentation is required to determine whether can continue to use.
 

Customer production site:

Advantage:

(1). Green environmental protection, no heavy metals, no waste discharge.
(2). Less investment, low cost
(3). Operation safety, not any harm to the spray plating personnel.
(4). Suitable for automated production, automated production line can be based on customer demand.
(5). Colorful, gold, silver, bronze, antique gold, yellow, red, blue, purple, etc.
(6). Recycling, spray plastic products can be smashed after the waste, then recycle.
(7). Wide range of application, all kinds of materials can be sprayed coating, no volume limit.
(8). A cross color can be Partial spray, the same product can be sprayed with different colors and effect pattern.
(9). Nanometer coating with less investment, green environmental protection. Color, material, size is not limited