Non - Inflammable Cationic Epoxy Electrocoat For Engineering Mechanical

Engineering mechanical grey electrophoretic paint

Product Introduction:

HS-6060LB/HS-2516G Gray Cationic Epoxy Electrocoat for auto is a new generation electrophoretic coating researched and developed by HLS Paint (Shanghai) Co., Ltd. It represents modern technology of cathodic electrophoretic coating that is environment-friendly with high property and low cost. Such coating does not contain heavy metal like lead, tin, cadmium and mercury etc. It is a two-component, water-dispersed resin,meanwhile, it took in features of previous products, and can adapt galvanized steel sheet perfectly, almost can be applied to foundation coating of all metal, such as: cold and hot rolled steel sheet, galvanized steel sheet, aluminum products, zinc-aluminum alloy sheet and stainless steel sheet etc.

This product features shown below: 

The main component Matrix resin:

Matrix resin​:polyurethane modified epoxy resin

Curing agent:totally enclosed multi-isocyanates

Additives: surface active agent, prevent shrinkage cavity agent

Product quality data :

Note: pH, conductivity measurement in the resin/pure water = 1:1 dilution

Filling tank proportion and method:

Bath preparation

Ratio:

Resin                                 1000.00-1250.00

Paste                                                 250.00

DI water                             1900.00-2200.00

Total                                  3025.00-3575.00

Bath on site management project:

Good bath data and coating quality, from the strict parameters management and maintenance of equipment, production line according to its own reality time situation, can have different management project and specifications, recommend the construction parameters see the table below for reference:

Storage, packaging and transportation:

This product is a water-borne industrial coatings, non-hazardous, non-inflammable and explosive products; transportation to prevent direct sunlight, avoid freezing (>5℃ ); Packaging for 50/60/200L Plastic barrel; in the transport and storage of drums should be maintained clean, avoid charging the dirt brought in on drums during filling tank, again checked and confirmed that the quality of products, including paste resin, emulsions and additives should be indoor storage, good ventilation, dry, protect against freezing and overheating, the storage temperature should be controlled at 5～35℃, products from the date of production, over shelf, experimentation is required to determine whether can continue to use.

Customer production site​: