Manual Installation Toilet Tank Fittings , Toilet Bowl Rubber Gasket

The toilet is installed with anti-odor blue glue, and the toilet is installed with sealing flange ring.

What is a sitting flange?
The flange ring at the bottom of the toilet (or flange ring, the toilet seal) is a gasket made of wax and placed on the ground.Installing a flange ring saves money and can solve the problem of water leakage in the toilet, avoiding more damage.
Many industrial bearings to shock and abrasion between rubber mat flange, the toilet is basic need flange installation, but a lot of toilet is another match. Butter, polymer, the latter is more popular.Toilet flanges (toilet seat ring) is between the drain hole and the water hole between the toilet, it ACTS as a seal, so the siphon toilet does not leak, the flushing effect is also very good.

Features:

1. The toilet is equipped with a good waterproof seal, high temperature resistance, corrosion resistance, aging resistance, dry operation, easy installation and disassembly.

2. Provide permanent leakproof sealing effect to prevent bugs, odor, gas and acidic substances from entering.

Use 3' or 4' in the toilet.

4.100% leak proof

5. More super glue.

How to install the flanged flange?

First determine the shutoff valve (the water valve or the total water valve in the toilet).Flush the water from the tank and pan.Drain the water tank and all the remaining water in the potty, which can be used with a thick towel or sponge.Remove the nut cover from the bedpan and unscrew the nut, which may require the use of lubricating oil and pliers.Disconnect the water supply.Gently move the toilet back and forth, loosen the wax seal and the glass.Take care of the bedpan, not the water tank.If you hold the water tank, you may break or break the connection between the tank and the basin.Remove the old wax seal rings on the combined surface.Open the new flange ring (which can be bought at the hardware store), and turn it round and round the flange on the ground so that it is right above the opening.Make sure two screws are in place.Lift the toilet, cover the flange and wax seal, and keep the toilet level as far as possible.Sit on the toilet to help seal the new flange ring and make sure the pan stays level.Reload the nut we just removed.Tighten the nuts with your hand to avoid cracking the bottom of the toilet.Reconnect the water supply.Open the water valve to fill the tank.Flush and check for leaks.If you need to glue between the floor and the bedpan.We're done!Well, it's not that hard, and remember to wash your hands with hand sanitizer.