Multifunction Rotary Electric Vegetable Slicer Fruit Potato Cutter
Slicer
This Vegetable slicer is a compound multi-function cutting machine developed by
simulating the principle of manual cutting, using advanced
technology such as “stepless speed regulation”, “infinite
adjustment mechanism” and “centrifugal slicing mechanism”. Widely
used in the processing of hard and soft roots, stems, leafy
vegetables and kelp, can be cut into pieces, silk, blocks and other
styles.
Precautions of Vegetable slicer
1. Wash the vegetables before cutting vegetables to avoid foreign
matter in the vegetables and damage the tools and other parts.
2. Do not put your hand near the cutter or reach under the safety
net during the operation of the machine to avoid danger.
3. Do not put your hands on the conveyor belt or the pressing belt
during the operation of the machine to avoid danger.
4. Do not activate the switch during machine maintenance to avoid
danger.
5. Do not perform any kind of repair and maintenance during the
operation of the machine to avoid danger.
6. The product's slicing knife and vertical knife are equipped with
safety shields and protective nets. Do not dismantle them at will
to avoid danger.
Maintenance
1. All maintenance work must be carried out with the power off.
2. After each use, carefully clean the machine. Do not use the
sharps to touch the conveyor belt and the vegetable belt when
cleaning. Do not spray with the spray pipe.
3. If the conveyor belt and the pressing belt are loose, the
tension bolts should be adjusted or the spring pressure should be
adjusted to the proper position. The tension or pressure at both
ends should be basically equal. Otherwise, the conveyor belt or the
pressing belt is prone to deviation.
4. Check the tightness and wear of the V-belt and adjust and
replace it in time. When the V-belt is loose, loosen the bolts of
the tensioning mechanism for adjustment, and tighten the bolts when
the V-belt is tightened.
5. Each shift will be injected into the ratchet, gear and sprocket
once. The oil No. 20 is used. The amount of oil is 10 drops per
time. The grease in the bearing is added and replaced according to
the usage. Calcium-based is selected. Grease grease.
6. In the machine work, if the machine sound is not normal, you
must stop the inspection immediately, and wait until the fault is
removed before you can continue working.
