Dpack Triple Layer Conveyor Bridge With Two Hand Railings , Stairs Three Groups corrugated carton package machine

Triple Layer Bridge Conveyor

Machine specification:

* Max paper width:2200mm

* Main frame made by H steel

* Take up device two sets,installed on each single facer and stand overhead the mill roll stand and pre-heater

* The cardboard take up to the bridge set up conveyor, its speed and the production speed to do synchronous,motor 2 sets.

* On the bridge with two hand railings, stairs three groups, catwalk made by 150MM rectangular tube and 1000MM wide steel grille

Main part brand:

* Electrical,main adopt ABB,SHNEIDER brands

* Motor,main adopt Taiwan TECO and Chengbang brand

* Take up device motor 5 KW * 2 Sets

Machine Introduction:

1. Adopts suction tension device, use high pressure adsorption motor to suction the single face paper, make it flat to input the next process.

2. Installing two operate board, could be adjust on the bridge and ground.

3. Paper receiving device adopts independent frequency conversion control, manufacture enough single face paper to wave type, and make sure enough storage of single face paper, to keep in-phase different speed in manufacture.

4. With feeding paper frame on the bridge and two conveyor belt to transport the single face paper to the bridge, forming wave type to storage the single face paper.

5. The Automatic adjust the position of single face paper, reduce waste paper ratio of the manual operation.

6. Equipped block part, in order to single face paper stack well on the bridge when the machine in high speed.