Metal Sintering Furnace For Carbon Sensitive Metal , Tungsten Alloy

Metal Sintering Furnace For Carbon-Sensitive Metal, Tungsten Alloy

This sintering furnace is applicable for and not limited to hard alloy products, high magnetic products, cermets products, ceramics products.

Functions:

*Furnace body positive pressure leakage detection

*Furnace body negative pressure leakage detection

*Vacuum sintering

*Partial sintering

It including:continuous,intermittent and static.

*Vacuum cooling

*Rapid cooling

Systems:

*Electrical control system

*Heating system

*Vacuum system

*Cooling water system

*Rapid cooling system

*Safety system

*Auxiliary system

Technical details

• Valid working zone size:600mm × 600mm × 1200mm
• Maximum loading capacity:1500kg,it depends on the product type.
• Maximum design temperature:1300℃
• Working temperature:1200℃
• Heating mode: graphite rod resistance heating
• Temperature control mode:3 zone independence temperature control
• Vacuum rate: in the empty furnace, clean and cold state, the vacuum degree reaches 1x10^-5 Torr (1.33x10^-3 Pa) after starting the pump units for 60 minutes.
• Leakage rate:≤6.65X10^-1 Pa/h(In the empty furnace, clean, cold state, within 24 hours of the average)
• Heating rate:5-10 ℃/min (full loading)
• Rapid cooling time:≤5h (Annealing temperature drops to 100℃)