1024 P / R Precision Rotary Encoder , Quadrature Incremental Encoder For Elevator

1024 P/R precision rotary encoder shaft 35mm K100 quadrature incremental encoder for elevator

Quick description of K100 incremental encoder

Environmental temperature: Operating:-20 ～+85°；storage:-25 ～+90°

Shaft load: Radial 90N; Axial 60N

Top REV: 3000RPM

Shaft Material: Stainless steel

Shell Material: die cast aluminum

Installation dimension: R50mm(spring plate 100T90)

Hollow shaft type: through hole (clamping ring at prior and clamping ring at rear)

About Encoder Vibration

Vibration acting on an encoder always cause wrong pulse easily.

So we have to pay more attention to encoder working place.

The more pulse per round, the narrower groovy spacing of grating, ore effect to encoder by vibration, when motor speed is low or even stopped, vibration acting on encoder shaft or encoder shell would cause grating vibration, in this way, encoder might show wrong pulse signal.

Video of Encoder products

There are plenty of encoder video if you still have any doubts on encoder, please email us directly or contact online service right now.

At the same time, you could also visit our YOUTUBY page easily.

Most of the encoder series have videos for reference.

Signal Circuit of encoder

1. The NPN Open Collector -- The NPN Open Collector(NPN) is an interface based on an output circuit with an NPN transistor.

An open collector is the unconnected collector connection of an NPN transistor, whose emitter is connected to earth and whose collector is connected to the output.

2. PNP output

The PNP output is an interface based on an output circuit with a PNP transistor.

3. Push-Pull output(HTL)

High Voltage Transistor Logic functions with a voltage supply in the range 10 and 30 V DC, with 24 V DC being the most usual.

“Low” is defined as an output of between 0 V and 3 V and “high” as between VCC and VCC - 3.5 V.

4. TTL RS-422 output

In a transistor-transistor logic (TTL), both the logical status and the amplification are done by transistors, hence the name.

The TTL output is supplied with either a fixed 5 V voltage or a variable voltage of between 10 and 32 V. For this the low range is defined as the ≤ 0.4 V and the high range as ≥ 2.4 V.

K100 Series Detail Specifications