Diesel Hydraulic Puller Pulling Equipment Long Service Time

Pulling Equipment Diesel 49.2hp/36kw Hydraulic Puller Max pull force 100kN

Hydraulic puller is suitable for laying underground transmission cables and optics fiber cables.

Hydraulic puller is driven by a diesel-hydraulic power unit that is completely enclosed within an area of coverage, limiting noise emissions.

Configuration

Control panel with instruments for hydraulic system and engine.

A dynamometer used to check pull values

Hydraulic oil cooling system

In the case of over pull, the preset for maximum tension can stop the puller

The hydrostatic loop, which allows the puller to continue to change speed in two rotational modes, can operate only one command

Hydraulic emergency brake operates automatically at the center of the instruction bar or in the case of hydraulic failure (not suitable for lifting)

Mechanical front and rear stabilizer

Grounding connection point

Large channel steel capstan with anti-skid device

Anti-twist Steel rope

D18mm 700m

We can customize the size and length as your request.

Hydraulic Transmission

Closed hydraulic circuit for step less speed variation in both rotating directions. This machine is provided with a pull pro-setting system that maintains the pre-set pulling value (also when the speed is reduced to "0") by automatically adjusting the operation speed according to the friction and unexpected loads which may occur.

Additional Devices

Lighting system for the trailer

Swivel guide rope roller

Chassis, with damping shaft, tires, traction lever, Trailer for towing at max speed of 30 km/h

Digital speed and meter counter (extra charge)

Accessories for anchoring and lifting

The heat exchanger cools the oil in the hydraulic circuit

Rear tension roller with hydraulic drive