Electricity Drive Electronic Stainless Glue Gun For Glue Application

Electricity Drive Electronic Stainless Glue Gun For Glue Application

Glue Applicator / Glue Gun is a component assembled in both cigarette makers and packers, applying glue to different paper materials.

1. Ferric Oxide For

hot melt adhesives provide several advantages over solvent-based adhesives. Volatile organic compounds are reduced or eliminated, and the drying or curing step is eliminated. Hot melt adhesives have long shelf life and usually can be disposed of without special precautions. Some of the disadvantages involve thermal load of the substrate, limiting use to substrates not sensitive to higher temperatures, and loss of bond strength at higher temperatures, up to complete melting of the adhesive. This can be reduced by using a reactive adhesive that after solidifying undergoes further curing e.g., by moisture (e.g., reactive urethanes and silicones), or is cured by ultraviolet radiation. Some HMAs may not be resistant to chemical attacks and weathering. HMAs do not lose thickness during solidifying; solvent-based adhesives may lose up to 50–70% of layer thickness during drying.

1. Glue Pot Stability

The degree of stability in molten state, the tendency to decompose and char. Important for industrial processing where the adhesive is molten for prolonged periods before deposition.

Bond-formation temperature

Minimum temperature below which sufficient wetting of substrates does not occur

1. Pigmented versions

The adhesives are usually clear or translucent, colorless, straw-colored, tan, or amber. Pigmented versions are also made and even versions with glittery sparkles. Materials containing polar groups, aromatic systems, and double and triple bonds tend to appear darker than non-polar fully saturated substances; when a water-clear appearance is desired, suitable polymers and additives, e.g. hydrogenated tackifying resins, have to be used.