CAB Electric Aluminium Radiator Brazing Furnace 1000 - 250 - 10000MM

CAB Electric Aluminium Radiator Brazing Furnace 1000 - 250 - 10000MM

Application 

This aluminium radiator brazing furnace can be used to braze auto aluminum radiators.

RRODUCTIVITY &CAPACITY (Typical Size)

Production line can be available to continuous brazing the following parts.

SCOPE OF SUPPLY

Degreasing Furnace

Fluxing System

Drying Furnace

Front Curtain Chamber system

Brazing Furnace

Air Cooling System

Rear Curtain Chamber

Air Blast System

Control System

Technical Parameters

Equipment Advantages

1) The aluminum radiator brazing furnace adopts high performance porcelain fiber cotton material for heat preservation purpose.

The furnace is able to rise to 630℃ from the ambient temperature in around 2 hours.

2) The muffle of the brazing oven is once-formed by the large size bending machine, and is made from Sweden 316L steel plate

and 304 steel plate. 8M muffle is formed by one-time bending, and only there is one v-slot at the bottom of the muffle. The complete

muffle is only with 2 side welding lines. The one-time forming muffle could reduce the misshapening effect at welding and also

deformation at the heating process.

3) The zones of the brazing furnace are divided based on upper, lower, rear and back area. The heating power is adjusted through

power and voltage regulator so that the furnace could achieve an ideal temperature uniformity of ±1℃. The brazing area could

achieve a temperature uniformity of ±2℃ so that it could meet the brazing requirements.

4) The temperature controller has the PID regulation function to achieve a smooth temperature rise. Also the temperature controller

has the over-temperature alarm. The mesh belt is steplessly regulated through the inverter. The driving mechanism is started up in the acceleration manner, and stopped in the deceleration manner to reduce the tension of the mesh belt.

5) the CAB aluminium radiator brazing furnace has a complete control system integrating intelligent control, alarm and protection system.

The real-time temperature recording function provide the process data of different products.

6) The area of the fluxing chamber which contacts the flux is made of stainless steel material. The two side walls of the fluxing chamber

are both set with an observation window to observe the fluxing performance. The fluxing nozzles have a 90º fan-shape spraying to prevent

nozzle blockage. There is a filtering net for recycling the flux to prevent damage to the fluxing pump.

7) The dry air cooling room is set with a slag cleaning chamber. There is a side door of the slag cleaning chamber for allowing the worker

to clean the flux slags. In comparison to the traditional water cooling chamber, the dry cooling room don’t have the risk of corrosion because

of water and deformation of the chamber because of cold and heat. There is no need for cooling water.

8) power at temperature rising stage: 100%; power at the brazing stage: ≤60%

Company Introduction

Our company mainly supplies the aluminum radiator making machines such as aluminum fin machine, aluminum radiator core builder,

aluminum radiator plastic tank crimping machine, aluminium radiator brazing furnace (or called as CAB brazing furnace) air leak tester,

header mold, plastic tank mold, etc.