JT-19 Dental Laboratory Gypsum Finisher Plaster Model Wet Trimmer Machine

Dental Laboratory Gypsum Finisher Plaster Model Wet Trimmer Machine

Description :
1. Motor Support
2. Motor
3. Abrasive disc
4. Protective case
5. Tightening screws of the abrasive disc
6. Working platform
7. Adjusting screws of the working platform
8. Power switch

Instruction :
1. Unpack the package,check if all the accessories are inside.Read this manual carefully before using
2. Fix the model trimmer to bench with one screw on each leg to avoid shaking
3. The tighten the water pipe and the joint tightly to avoid breaking off,which might cause water splashes and damage the motor
4. Tighten all the screws on the machine to avoid shaking
5. Turn on the power,notice if there any noise in the motor and check if the abrasive disc,change the water pressure if the result is not good
6. Input water
7. The trimmer can be adjusted which makes it easy and convenient .The angles can be adjusted by more than 30 °, the trimmer angle can be with 75 °-105 °

Specifications :