Polymer Carbon Fiber Strips Prepressed Cost Effective Wide Application Wall Support

Crack Repair Carbon Fiber Reinforced Polymer Prepressed Carbon Fiber Strip With High Strength

Tensile Strength: 2400Mpa(350000psi)

Modulus of Elasticity: 131000Mpa

Elongation at break: 1.87%

Thickness: 1.2mm, 1.4mm

Width: 10mm, 30mm, 50mm, 100mm

Crack Repair Carbon Fiber Reinforced Polymer Prepressed Carbon Fiber Strip With High Strength

Carbon Fiber Reinforced Polymer (CFRP) Post-tensioning Systems

Prepressed Carbon Fiber Strip is high strength and modulus materials which can strengthen the building and bridge for seams, columns, 

Post-tensioned systems are effective for control of structural cracks and deflections and to increase fatigue resistance and seismic resistance. provides a unique system based on post-tensioned CFRP plates.

CARBON FIBER STRIP

Thickness:1.2mm, 1.4mm, 2.0mm, 3.0mm

Density: 1.6g/cm³

Packing: 100 meters/roll

Width: 50mm, 100mm or to be customized.

Carbon fiber reinforced polymer(CFRP) strip/plate/laminate is pre-cured composite laminates, bonding onto the structure as externally reinforcement using XQ-JGN31P epoxy resin as the adhesive.

Carbon fiber laminate/strip/plate strengthening systems for strengthening, repair and rehabilitation of masonry, concrete, steel and wooden structures.

Main Performance

Remarks: all technical data are average values.

Application:

• Before applying the structural adhesive to the laminate, the sanded side of the laminate is wiped with acetone or other solvent until any excess residue (e.g., carbon dust) is removed. Observe proper fire and health precautions when using solvents.

• Apply thin prime coat of CFRP sheet to the substrate surface using a ¼” nap roller or brush. Application should be 1/2” wider than the plate to be used.

• Apply 1/16” (1.5 mm) thick coat of the thickened CFRP sheet to the cleaned, sanded side of the laminate surface. Plate laminates should be applied with approved epoxy adhesive.

• Press the laminates against the working surface using a hard rubber roller to achieve a void free bond line with thickness between 1/16” to 3/32” (1.5 to 2.5 mm). Excess adhesive is then removed from the sides of the laminate before it cures.

• The laminate may be coated with a protective or decorative coating.

• Test plates may be simultaneously installed adjacent to the area being strengthened and should be prepared using the same method described above. Bond pull-off tests are performed to validate proper installation. The bond strength of the plate to concrete may be verified by random pull-off testing at the discretion of the engineer. Minimum tensile strength of 200 psi must be achieved.

Our main product series:

-- Carbon fiber reinforcement system,

XQ-XW carbon fiber epoxy adhesive

XQ-XB concrete surface leveling epoxy adhesive

XQ-CFC carbon fiber fabric 12K unidirectional 200gsm-600gsm

-- Chemical Anchor series

Pure Epoxy Adhesive 360ml (5:1) 390ml(3:1) 585ml (3:1)

-- Steel bonding reinforcement system

XQ-JGN structural epoxy adhesive

XQ-GZ Grouting epoxy adhesive

XQ-FB edge sealing adhesive

-- Concrete repair system

XQ-GF crack grouting adhesive

XQ-FF crack sealing adhesive

.