Automatic Foil Stamping And Die Cutting Machine 800X580MM 7000s/H

Feeding Unit
• Pile tray with handle allowing manual lateral correction of the pile during production
• Stream-wise feeding system with a highest speed of 120 sheets per minute
• 2 suction cups each for lifting paper, 2 suction cups for moving paper
• Height and angle of suction heads are easily adjustable
• Electronic safety devices preventing feeder pile from over ascending
• Micro-adjustment is available for transversal positioning of pile table
• Precision double-sheet detector
• Easy changeover of pull and push side guides simply by turning a bolt without the need of removing and replacing complete side guide
• 2 front guides with micro-adjustment and the side guide is adjustable by wheel handle
• Photo-electric detector with automatic stop system on feeding table in case of paper jam
• Separate drive controls of feeding unit & the main machine for easy make ready
• PLC and electronic cam for timing control

Die cutting Unit
• Siemens main motor controlled by Schneider inverter control
• Micro-adjustment of cutting force by worm gear driven by motor and controlled by touch screen
• The pressure accuracy can be up to 0.01mm
• Crank shaft made of 40Cr steel
• Machine frames made of Q235-A Steel, upper and lower platens made of QT60 ductile iron with resin coated sand with Meehanite Die Cast Iron Technology
• Cutting chase turn-over device
• Overload protection device with torque limiter for the highest safety of operator
and equipment
• 7 sets of gripper bars with grippers made of lightweight and durable aluminum
alloy with ultra hard coat and anodized finish ensure accurate and consistent
paper registering
• After long run test and delivered in pairs, main gripper, chain from Subaki,
Japan
• High pressure index drive system for gripper bar positioning control
• Pneumatic lock-up and release of cutting chase
• Centerline system for quick job changeover

Stamping unit
• The 2 longitudinal and 2 transversal hot stamping axes fully meet the customer's hot stamping needs for products.
• The uniform heating of 10 areas enables the product to show a more uniform hot stamping effect.
• PLC control servo system.

Delivery Unit
• Safety photo-electric devices preventing over-ascending and over-descending of delivery paper pile
• Adjustable depressor brush helps unloading paper from grippers and piling up paper
• High pile design up to 1020mm
• Automatic auxiliary belt table available for non-stop delivery
• Feeder movement and speed control can be adjusted in the delivery unit

Electric Parts, Operator Interface and Safety Detector
• The high speed Japanese industrial Omron PLC system
• Omron operator interface with touch screen
• Omron Electronic cam switch and encoder
• Electronic detectors, micro switched and photo-electric cells controlled by PLC on entire machine

Automatic Lubrication System
• Automatic oil pump and distribution system for entire machine with preset timer
• Lubrication oil distribution for gripper chains with individually controllable valve for each chain

Safety Devices and Quality Approval of Components
• All electronic and electrical parts are CE approved
• Overload protector for the protector and equipment
• Gripper chain clutch for the protection of gripper bars
• Emergency stop buttons on entire machine for quick and easy access