Processless Aluminum DOP Thermal CTP Plate 0.30mm For Offset Printing

Development on Press Thermal Processless Plate Negative CTP Plate 

Application 

EcooGraphix ECOO-G is a new, environmentally friendly, Development On Press CTP plate.

It can be run directly on a printing press after imaging, without a need for chemical processing.

Recommended application to press procedures of ECOO-G:

1. Clean all the inks on the blanket;
2. Start the press machine, apply the water roller, run 30-40 seconds;
3. Apply the ink rollers 20-30 seconds;
4. Apply the paper and start print.

Remark: If steps 2 and 3 are longer, the paper will be wasted less.
 

Specification 

Model

ECOO-G

Plate Type

Thermal-negative type

Application

High-grade commercial and newspaper printing

Substrate

Electrolyte graining and Anodized AL substrate

Thickness

0.15mm/ 0.30mm

Maximum short grain width

Maximum width 1280 mm

Spectrum scope

800-850 nm

Photosensitive wavelength

830 nm

Platesetter

Various dominant thermal platesetters in the market

Coating color

Grey

Low-energy imaging

130-150 MJ/cm²

The period of latent image stabilization

≤ 7 days

Recommended screen method

1-99% @200 LPI AM or 20μm FM or mixture

The paper number of start-up

< 50 sheets

Safety light

4 hours under yellow light;

1 hour under a fluorescent lamp;

Direct exposure under natural light is safe but not recommended.

Processing

Without processing, directly on the press

Run Length

100,000 impressions; Actual run length depends on printing conditions

Shelf life

12 months under recommended condition

Transportation

Packed in seal and stored using prevention from light, moisture, overheating, and high humidity.

​

​

Applied parameters in the Imaging device

​

*Note: Higher exposure energy will make the image contrast clear, and benefit the plate run length;

while over-high/low exposure energy will affect the image quality negatively.

ECOO-G Processless CTP plate Video: https://youtu.be/LLqNaY1ivcI
​

Characteristics 

ECOO-G is a double layer, and the emulsion layer will not dissolve in water,

so it will not integrate into the fountain solution;
while the protection layer is well water-soluble, and it will be easily dissolved into the fountain solution.

Customer Feedback

 Producing And Packaging