Intelligent Door Endurance Tester for Microwave and Refrigeration Appliances

Power Supply

Two-phase: 220 V (phase-to-phase), 60 Hz

Test Station

3 station

One station for opening and closing doors left and right, one station for flipping doors, and one station for opening and closing drawers

Control Mode

PLC intelligent integrated control, 7-inch humanized touch interface operation

Drive Mode

Servo motor drive

Available Sample Type

Allowable sample size range:

Left and right door open/close station (middle): WDH≤1910×928×2035mm

 (Samples with 2 vertical doors at the same side or 1 door shown as following)

2. Flip door open/close station (right side): WDH≤1100×600×1000mm

3. Drawer open/close station (right side): drawer stroke ≤ 500mm

Clamping Method for Door

Vacuum suction cup, pneumatic

Refrigerator/oven left and right door open/close station

Door opening and closing mechanism

Two sets, 1 set for opening and closing the upper door and 1 set for opening and closing the lower door, individually operation, no interference

Column 1

2m height, the built-in screw guide adjustable mechanism can adjust the position of the upper and lower door opening mechanical arm to match different refrigerator door heights

Open/close angle

0-90°, can be preset

Open/close direction

Left or right

Open/close cycles

0-999999 cycles, can be preset

Open/close speed

6-18 cycles /min

Oven/microwave oven flip door open/close station

Open/close mechanical arm

1 set

Column 2

1.2m height, the adjustable mechanism of screw guide rail can adjust the position of flip cover manipulator to match the height of different sample covers

Open/close angle

0-90°, can be preset

Open/close direction

Flip hinge up

Open/close cycles

0-999999 cycles, can be preset

Open/close speed

6-18 cycles/min

Drawer open/close station

Drawer open/close mechanical arm

1 set

Column 3

1.2m height, the adjustable screw guide rail mechanism can adjust drawer manipulator position to match different sample cover heights

Open/close stroke

0-500mm, can be preset

Open/close direction

Along the front and rear directions of the drawer rails

Open/close cycles

0-999999 cycles, can be preset

Open/close speed

6-18 cycles/min

Left or Right Door/Dlip Door/Drawer Open and Close Method

The Vacuum suction cup sucks on the door tightly, then servo motor drives the door opening and closing mechanism back and forth, the door opening and closing frequency, door opening and closing angle, test cycles can be set and displayed on the touch screen

Sample fixture

One left set and one right set

Auxiliary unlocking mechanism

One set, configurated on flip door open/close station 

Load Voltage

0-250V, adjustable

Safety Protection

Power

Leakage protection, overload and short circuit protection

Motor

Overload, short circuit protection