IEC60529:2013 High Quality IPX3~4 Oscillating Tubes Test System Product information:
IPX3~4 oscillating tubes test system is designed and manufactured
according to IEC60529:2013. It is used for testing the IPX3/IPX4
waterproof level of electrical and electronic products. The complete set of IPX3~4 oscillating tubes test system is
composed of one set of oscillating tubes swing device, one full set
of oscillating tubes of R200mm,R400mm, R600mm, R800mm, R1000mm,
R1200mm, R1400mm, R1600mm, a turntable, and an intelligent water
supply and control cabinet. The intelligent water supply and control cabinet is composed of a
water supply tank, a water pump, and a control system. The test
water supply flow is controlled by a PLC, a frequency converter,
and a flow meter.
Technical parameters:
No. | Item | parameters | 1 | Water supply | Water flow rate＞10L/min±5% clean water without inclusion.
This device is equipped with clean water filtration unit | 2 | The size of the oscillating tube | Coming with R200mm,R400mm, R600mm, R800mm, R1000mm, R1200mm,
R1400mm, R1600mm oscillating tubes, made of stainless steel | 3 | Needle hole | Φ0.4mm | 4 | Included angle of two holes | IPX3:120°; IPX4:180° | 5 | Oscillating tube swing angle | Max. ±175° can be preset
(Note: standard requires IPX3:120°; IPX4:360°, but due to there is
turntable under oscillating tube during test, so 360° can not
achieved during actual testing, if without turntable, then 360° can
be achieved) | 6 | Raining speed | IPX3:4s/time (2×120°);
IPX4:12s/time (2×360°); | 7 | Water flow | Can be set according to the size of the oscillating and the number
of the pin holes (0.07 L/minX per hole) | 8 | Testing time | 1-99999S can be preset | 9 | Pressure gauge | 0~0.25MPa | 10 | Turntable | Diameter: Φ600mm, rotation speed: 1r/min, bearing capacity: ≤50kgs | 11 | Site requirements | Dedicated IP waterproof test room, the ground should be flat with
illumination.
10A waterproof leakage switch (or socket) used for equipment. With
good function of inflow and drainage.
Ground installation. | 12 | Electrical control | PLC & touch screen | 13 | Power supply for this equipment | AC 380V, 50Hz, 4KW | | 14 | Power supply for sample | AC220V, 10A |
|
