IEC 62552 Customized Stations Automatic Drawer Push And Pull Testing Machine

IEC 62552 Customized Stations Automatic Drawer Push And Pull Testing Machine

Standard:

Drawer push-pull testing machine is designed and manufactured according to IEC62552: 2015 and customized requirements. It is used for the durability test of the drawer of the vertical freezer, and also used to cooperate with the energy efficiency performance test of the refrigerator to open and close the door. It is a dedicated fully automated testing equipment, suitable for testing and certification agencies, factory laboratories and other testing departments.

Technical parameter

Equipment principle: Drive the manipulator through the air cylinder, pull the soft rope to drive the drawer closed by the suction cup to the maximum limit, then the air cylinder pushes the pressing wheel to close the drawer, and each pull and push of the drawer is a cycle.

Test machine structure: as shown in the figure below, the overall frame structure is adopted, and the sample is placed on the bottom plate of the equipment, so that the relative motion is internal stress and the shaking of the equipment is reduced. A column-type structure is installed on the bottom plate, and the column contains 3 sets of drawer push-pull mechanisms, as shown in Figure 1 below, which can meet the test up to 3 drawers.

Test Equipment Unit Introduction

The design of the system is based on the principle of modularization, and is designed and manufactured in strict accordance with the requirements of the standard, and at the same time, standardized design and components are used as much as possible. Ensure that the system has optimal performance and technical support.

The use of cylinder drive ensures the high reliability and extremely long service life of the entire system.

The whole system has clear functions, compact structure, beautiful appearance and reasonable layout, which is convenient for maintenance and daily maintenance.

The design and manufacture of the equipment meet the general technical requirements of the customer for the equipment.