IEC 61009-1 Circuit-Breakers 500mm Mechanical Impact Test Machine

IEC 61009-1 Circuit-Breakers 500mm Mechanical Impact Test Machine

System configuration:

The test equipment conforms to the standard requirements of IEC 61009-1:2012, IEC60898-1:2015 clause 9.13, etc.

It is used for switch sockets, surface-mounted installation boxes, contactors, molded case AC air circuit breakers, etc., to verify the impact resistance of exposed parts that may be subjected to mechanical impact during normal use.

Test principle: According to the test Eha: the pendulum, the impact element is released freely at a certain height through a 1-meter pendulum, hits the sample at the lowest point in the vertical direction, and through the transformation of gravitational potential energy into kinetic energy, the purpose of impact testing on the sample is achieved.

Features: This equipment, also known as low-energy pendulum impact test device, adopts a floor-standing structure and does not need to be installed. The sample mounting bracket can be adjusted up and down, left, right, and front and rear. At the same time, it can be adjusted around the axis perpendicular to the mounting plate and the mounting plate can rotate around the vertical axis, a total of wuzhou2 adjustable. The swing rod can adjust the release angle through the pivot, so as to achieve the impact on different positions of the front and side of the sample, covering the impact test requirements of most similar products.

Technical parameters:

Details Display: