Thermal Durability Test Led Testing Equipment Large Luminaires Temperature Aging Room

Luminaires Aging Test Room LED Light Thermal Durability Testing Equipment

Overview:

The luminaire durability aging test room meets the requirements of Section 12.3 of the Chapter 12 “Endurance Test” and Annex K “Temperature Measurement” of IEC60598-1:2014.

This testing system has excellent cost performance, long-term operating temperature stability, high precision test data, good test results, highly recommended by lighting manufacturers, quality and technology supervision and inspection institutions, third-party testing laboratories and etc.

Features:

The durability aging test room for luminaires can control the ambient temperature during the testing, adopts the method of circulating heating or cooling indoor air, and with advanced PID temperature control technology to stabilize the within the set range. Balanced temperature control system (BTC) + special forced air duct air circulation system, the SSR is controlled by P.I.D., ensure the heating amount of the system is equal to the heat loss amount, so it can be used stably for a long time. The environmental test chamber consists of a test chamber and a refrigeration-heating unit.

Technical Parameters:

Lamp Constant Temperature Durability Aging Room (Large) - Structure and Heat Cycle Diagram

Structure and Material:

a) Inner chamber material: clean and thick flame-retardant color steel plate (the inner wall needs to be painted black)

b) Outer chamber material: sprayed color steel plate

c) Insulation material: thermal mineral wool

d) Heater: good heat dissipation

e) Refrigeration system: France TECUMSEH brand refrigeration compressor

f) Provide high temperature / heat / corrosion resistant black floor

Luminaires Test Installation Workbench/Bracket:

Casters are mounted on the bottom of the luminaire test installation workbench. It is easy for installation, and can meet the installation requirements of fixed lamps (ceiling lamps, wall lamps), recessed lamps, table lamps, street lamps and other lamps. There are 2 layers on the installation workbench, overall size is about 1800mm * 1000mm * 1400 mm (length x width x height) (the first layer is about 400mm high, the second layer is about 1400mm high), each layer is equipped with about 10 power sockets. Each layer can be individually powered for 24 hours and 3 hours for power off.