Mini 10hp Swimming Pool Heat Pump Heavy Duty With Non - Leaky Design

Heavy Duty 10HP Swimming Pool Water Pump Mini Spa Pool Heat Pump

Features:

1) Magnificent flow rate and lift, the core energy of water circulating, 2~3m suction lift
2) Engineering plastic body, the pump can be effectively protected under bad weather,long service life;
3) Seiko manufacturing, low noise during the pump working time;
4) Free-tool filter cover design, easy to maintenance;
5) IP55 protection level, with None-leaky design;
6) German technology IBC bearing, 100% copper wire motor, 24 hours running.
7) Anti-rust cast-aluminum motor cover, fast heat dissipation; PPO plastic steel material impeller, resist high temperature and corrosion
8) Silicone sealing ring cover all watering section, enhance pump sealing system
9) CE certificated, reliable and safety

Release all air from fitter and piping system: see filter owner manual

In a flooded suction system (water source higher than pump),
pump will prime.
it self when suction and discharge valves are opened.
If pump is not in a flooded suction system, unscrew and remove cap
cover; fill cap and pump with water.
Clean and inspect Ring; re-install on trap cover.
Replace cap cover on cap turn clockwise to tighten cover.
PRIMING PUMP

1) Magnificent flow rate and lift, the core energy of water circulating, 2~3m suction lift
2) Engineering plastic body, the pump can be effectively protected under bad weather,
long service life;
3) Seiko manufacturing, low noise during the pump working time;
4) Free-tool filter cover design, easy to maintenance;
5) IP55 protection level, with None-leaky design;
6) German technology IBC bearing, 100% copper wire motor, 24 hours running.
7) Anti-rust cast-aluminum motor cover, fast heat dissipation; PPO plastic steel material

1. Unscrew cap lid(turn counterclockwise).
2. Remove strainer basket and clean. Be sure all holes in basket are clear, flush basket with water.
If basket is replaced backwards, cover will not fit on pre-filter body.
3. Clean and inspect lid Ring: re-install on cap cover.

WITH A FULL RANGE OF SIZES, they are IDEAL FOR SMALL, MEDIUM and LARGE spas – Our pumps start from the 0.5 HP for circulation pumps up to the 3HP for spa jets and a full range of sizes in between. Connection fittings for standard PVC 2inch (48.5mm) pipe.

HOW TO USE – It is best to always replace your pump with a pump of similar size and power rating. Changing over and fitting of the pump can be done by the handy person but it is recommended to get it done by a professional. Suitable as a direct replacement OR upgrade to existing pump.