Double Fence Panel Welded Wire Mesh Welding Machine For 2500mm

Double Wire Fence Panel Wire Mesh Welding Machine

Optional equipment:
Straight cut-off machine, air compressor, gas storage tank, cold dryer, air source purification equipment.

1 The welding gas storage device is equipped with air filtration devices and oil filter device, which can greatly increase the service life of pneumatic components of the equipment.

2 The improvement of design of welding transformers meets the demand to weld continuously wires of 8+6+8mm at a high speed at the moment when saving energy
3 The machine is mainly used for welding building mesh and road and bridge construction.

8 + 6 + 8mm Double Wire Fence Panel Wire Mesh Welding Machine long wire feeding car

Manually put the pre-cut long wire into the position hole , start the 8 + 6 + 8mm Double Wire Fence Panel Wire Mesh Welding Machine button and the pneumatic clamp will clamp the wire tightly, then the stepping motor will drive the wire to be welded by welding host.

Later the 8 + 6 + 8mm Double Wire Fence Panel Wire Mesh Welding Machine mesh traction car will pulling the mesh by going there and back. When welding the second mesh, the feeding car will back to the original point and still for preparing the wires of the second mesh. As soon as the first mesh is finished, it will work again and followed by recycling. There is no need to stop the welding machine, which improves the welding efficiency.

The whole set of 8 + 6 + 8mm Double Wire Fence Panel Wire Mesh Welding Machine is composed of machine rack, feeding car, clamping device and transmission device.