ISO Metal Sheet Forming Machine 5m/min For Floor Deck

ISO Metal Sheet Forming Machine 5m/min For Floor Deck

The introduction of equipment

Technical specifications

Manual inner tight decoiler

a. coil inner diameter 450mm-550mm

b. maximum width of coiling 1200mm

c. maximum weight of loading 5000kg

Main forming machine

a. number of forming steps depend on the machine

b. material of shaft45# steel . Outer diameter90mm

c.main motor power3kw

d. The speed of forming:8-10/min

Hydraulic cutter

a. material of blade:Cr12 mould steel quenched treatment60-62

b. cutting system :adopt advanced hydraulic drive, after forming automatic cut,

no distort, no wasting , high safe factor.(main motor stop cutting)

The electrical control system

a. The Brand of display:Taida

b. The main computer (PLC):Tai Da DVP14

Hydraulic system

a. Adopting advanced hydraulic system of Tai Wan

b. Power:3kw

The equipments coating,package

a. the coating adopt international general shade-guide

b.The package :simple waterproof package.

The spare parts of the equipment

a. the element of easy damaging :contactor conk: 2 unit ,fuse: 4 set

b. the hydraulic sealing up cushion: 1set

c. Bolt spanner: 1 set

Note for use and maintenance

1) before use,you must check whether all connections are steady,whether bolts

and nuts are tightinstallation.when start the machine,you must make sure there

are enough lubrication oil in the case.

2) when start the machine commissioning,the machine should run idle,then

check it carefully such as noise,vibration and whether the oil window works

smoothly,whether every parts movement coordination.

3) You must cut off power when install the mould,move the motor belt and

big gear by hand,turn the workbench and make sure the slide up to the highest point.

Final products