1060mm Fully Automatic Hot Stamping And Die Cutting Machine
Carton Box Die Cutting Machine Introduction
The automatic flat-bed die-cutting and hot stamping machine is a
new generation of automatic flat-bed die-cutting and hot stamping
machine developed by our company after years of design and
innovation. Die-cutting, bronzing, creasing and cold pressing of
paper cartons, cartons, and trademarks in the industry, especially
various high-level and fine prints, such as cigarette boxes, wine
boxes, gift boxes, small household appliances boxes, cosmetic
boxes, etc. Both can be used for ordinary bronzing and embossing on
this machine to obtain three-dimensional, exquisite and beautiful
printed products. This machine realizes automation from paper
feeding, die cutting, hot stamping, and paper delivery. It can
realize the functions of automatic detection, fault display, and
non-stop sampling. It also has the advantages of high die-cutting
pressure and high registration accuracy. The main drive system of
the machine is equipped with a pneumatic clutch and a braking
device; a torque limiter (safety clutch) is installed on the main
sprocket shaft; and multiple safety detection electric eyes and
safety devices, etc.; can avoid the operation due to emergencies to
the greatest extent The injury and equipment damage caused by the
operator shall fully protect the safety of persons and equipment.
Parameter of Die Cutting Machine
| Maximum paper size | 1060×760 mm | Anodized aluminum foil feeding servo system | Vertical 3
Horizontal 2 |
| Minimum paper size | 390×290 mm | Maximum diameter of anodized aluminum foil | Verticalφ250 mm
Horizontalφ200 mm |
| Maximum die cutting size | 1055×750 mm | Temperature control area | 20 independent areas |
| Maximum hot stamping size | 1050×745 mm | Maximum speed | 7500 sheet/h |
| Paper | 0.1～2.0 mm | Grip mouth blank size | 8～17 mm |
| Corrugated board | ≤4 mm | Maximum working pressure | 300 T |
| Speed | 7000sheet/h | Power | 46 KW |
| Precision | ≤±0.075 mm | Weight | 20.5 T |
| Dimension | 7570×4650×2530 mm |
Main Units
|
Feeder feeding unit
1.Overweight feeder paper feeding mechanism
2.The size of the processed paper can be input to the man-machine
interface. After the system is calculated, the operator can
automatically adjust the front and rear positions of the feeder
head through the man-machine interface.
3.Fish scale paper feeder, maximum speed 125 sheets/min
4.Independent pre-coded paper mechanism, the work paper stack can
be maintained at any time when stacking paper
|
|
Die cutting unit
1.Servo-controlled pressure regulating device adopts a gapless ball
screw to make pressure regulating accurate and reliable
2.40Cr crankshaft
3.Worm 20Cr is ground after carburizing and quenching
4.The left and right wall panels, upper and lower platforms and
bottom platforms of QT60 resin sand craft ductile iron
5.Die cutting bottom plate and knife template rotating device
6.The lubricating oil air-conditioning forced cooling lubrication
system in the main transmission box
|
Finished Products
Machine details
