Wireless Remote Control For 3-Joystick
6-Mechanism Four Speed Crane
Main function: The joystick is pushed back and forth, left and right to control
the lifting hook up and down, the small car runs left and right,
and the large car runs back and forth. The joystick is in a self
reset mode, and the 5-speed speed control button is in a jog mode.
The joystick is pushed back and forth, left and right to achieve 5
speed control gears, and each joystick corresponds to a 2-speed,
3-speed, 4-speed, and 5-speed relay at the receiver end. When
pushed back and forth, the 2-speed, 3-speed, 4-speed, and 5-speed
relays are shared, When pushing left and right, the 2-speed,
3-speed, 4-speed, and 5-speed relays are shared. The four
directions of the joystick only have corresponding receiver end
1-speed relays, which means that the switch values that determine
the direction are not shared. The four switch value relays that
determine the direction are all separate.
Product highlight: Good anti-interference performance, with unique identification
codes between each remote control transmitter and receiver,
reaching hundreds of millions of sets, never repeating, and
strictly avoiding mutual interference and potential interference.
And the remote control has up to 50-256 frequency points, and each
set in the same environment can be configured with separate
frequency points. Even if the frequency points overlap, given the
uniqueness of the ID identification code, there will be no impact
on each other, ensuring safety and reliability.
Usage: crane, overhead crane, crane, electric hoist, gantry crane,
cantilever crane, portal crane, port crane, wharf crane, ship
crane, bridge erecting machine, beam lifter, etc. within the
4-point switching value, as well as elevators, hoists, lifting
platforms, winch, motors, plate shears, sand screeners, concrete
pumps, electric flat cars, industrial furnace doors, winch winches,
etc.
Technical parameters: remote control distance of 100 meters, 250 meters, working
temperature of -35 ° -+75 °, transmitter power supply of 3 No. 5
dry batteries of 4.5V, receiver terminal conventional working
voltage of 12-24V AC/DC, other voltages of AC220V or AC380V, etc.,
can be adapted through external transformer voltage conversion.
Model and configuration instructions: This machine model comes
standard with 1 transmitter and 1 receiver. The transmitter antenna
is built-in, and the receiver is equipped with an external extended
suction cup antenna (1 meter long feeder), which is attached to the
outside of the distribution box and installed inside the receiver.
