CE High Flow 4000W Solar Water Pump Controller Solar Variable Frequency Drive

0:NO ACTION

11:Restore default parameter except for motor parameter and auto-tune related parameter and factory parameter

12:Restore default to factory parameter 13:Clear tripping record

0:keypad

1:terminal

2:communication

Ø Command source: run,stop,forward,reverse,jog,fast brake stop.etc

00001:Output three phase 50HZ

00002:Output three phase 60hz

00021:Output single phase with capacitor 50hz

00022:Output single phase with capacitor 60hz

00031:Output single phase without capacitor 50hz

00032:Output single phase without capacitor 60hz

0:No function

1:READY

2:RUN

3:Error1(stop fault)

4:Error2(same as Error1 except undervoltage)

5:Warning output(fault but in running)

0:Three phase AC asynchronous motor

1:Single phase AC asynchronous motor without starting capacitor

0.1kW～710.0kW

Ø when power is less than 1kw ,0.75kw set to 0.8 as per round up principle ,0.55kw motor set 0.6

Ø when change motor rated power,AC drive will automatically set other parameter of motor name plate and motor model parameter be careful to use

P11.02<30kW:0.01A

P11.02>=30kW:0.1A

0:Standard mode (display frequency only)

1:Automatic scrolling display(Check 3.1 in detail )it show hz,current,power and voltage

Unit:hour

0: invalid

The parameters behind the 47 group cannot be changed!

1: Enable, to enable the special mppt function of the PV pump inverter

Solar pump control mode

Units digit’s: Startup mode

0: Manual start, the start mode is determined by P00.06;

1: automatic start,

When P00.06 change, the association changes here.

P00.06=0, when inverter starts and stops by keypad control, it is automatically modified to 1-automatic start

P00.06=1, when inverter starts and stops by terminal control.it is automatically changed to 0-manual start

Ten digit’s: MPPT function

0: MPPT is disabled; CVT control is used (voltage is given as P47.04).

1: Enable MPPT.

Hundred’s unit automatic switching function

0: prohibited

1: enable

Automatic switching is enabled, when the light is weak, it will automatically switch to the electric supply, and the MPPT function is disabled at this time.

Set the starting voltage of the MPPT algorithm.

When the MPPT function is disabled, this value is the reference voltage.

If the output frequency is lower than this value and exceeds P47.06, it will be reported to Sleep and stop

If automatic switching is enabled, it will switch to ac grid operation, and the MPPT function will be disabled

After the sleep fault is reported, if the time when Vdc is higher than the undervoltage point is greater than the set value, the fault state is exited and the operation continues.

When the automatic switching is enabled, after switching into the electric supply operation for this time, it will try to switch into the photovoltaic operation.

Unit digit:fast starting

0:Disable 1:Enable

Ten digit:Fast mppt tracking

0:Disable 1:Enable