110kV/132kV Electric 4 Legged Angular Steel Tower Cellular
Transmission Tower
Suspension Towers
Mainly the Suspension towers are on the way of that straight line
of transmission line . It may also vary maximum to degree of 5
angle . The high voltage suspension towers are design to carry the
only weight of the conductor in straight line position.Most of
towers in any transmission line is fall into this type of tower
category and construction cost of suspension type transmission
lines are much cheaper compare to other types of transmission
lines.These type of towers are used on the lines for straight run
or for small angle of deviation up to 2° or 5° . Conductor on
suspension towers may be supported by means of I-string, V- string
or the combination of I & V strings.
Tension Towers (Angle)
Electrical Tension towers are used at locations where the angel of
deviation is more than degree of 5. These towers are also known as
angle towers and the tower are designed to take the tension load of
the cable. Tension towers are mostly use for turning points and for
the section isolate locations.
| Product Parameters |
| Material | Steel Q235B/Q345B/Q420 |
| Quality Control | ISO/GB |
| Voltage Grade | Normally 35KV, 66KV, 110KV, 220KV |
| Surface Treatment | Hot Dip Galvanization |
| Color | Sliver |
| Connection | Bolts and Nuts |
| Usage | Power transmission and distribution |
| Quality Standard | ISO9001:2008 |
| Welding Standard | AWSD1.1 |
| Galvanization Standard | ASTM123 |
| Available Height | 5-80 m |
| Wind Pressure | 5-180KM/H |
