Applied To Glue / Ink Simple UV LED Curing Equipment

Applied To Glue / Ink Simple UVLED Curing Equipment

Equipment maintenance and maintenance:

1. In order to prolong the service life of the uv-led curing machine and ensure the normal operation of the

equipment, the equipment should be checked before starting the machine, and the problems should be

corrected in time.

2. Start running continuously for half an hour. Observe whether the indicators and indicators are normal,

and whether there is any abnormal sound during operation. If abnormalities are found, check immediately.

3. Clean the panel at least once a month and check whether the screws of each part are loose.

4. Avoid touching the lamp tube with your hands to prevent sweat and oil from affecting the ultraviolet light

transmission. If it is accidentally contaminated, it can be wiped clean with alcohol cotton.

5. The lamp and reflector should be wiped with alcohol once a month to keep them clean. If the surrounding

environment is bad, increase the number of cleanings accordingly.

6. The exhaust fan should be cleaned every three months to clean the fan blades, the outside of the casing

and the appearance of the motor.

7. Add lubricating oil to each rotating part of the fan, adjust the air valve drive mechanism, tighten each

terminal, and check whether the air valve drive mechanism is flexible and reliable, whether the wires are

damaged, and whether the wire connectors are well tightened.

8. If the uv-led curing machine is not used for a long time, it is advisable to loosen the conveyor belt to make

it in a free state.

9. After a period of use, the transmission chain will naturally extend and should be adjusted in time. During

the use of the conveyor belt, due to temperature changes, there may be deviations, and should be adjusted in time.

10. Ensure the lubrication of the active parts of the uv-led curing machine. The active and passive rollers,

bearings, chains and transmission wheels should be greased once every six months; other parts and motors

once a year, the front and rear rollers, rollers and the meshing part of the transmission net No grease is allowed.

11. After each use of the uv-led curing machine, clean up the dirt and dust to ensure that the mesh belt runs freely.

12. Frequently check whether the plug of the uv-led curing machine is in good contact with the socket. For

example, when the uv-led curing machine is running normally, if the cable is found to be hot, we must stop

the machine to replace the cable in time to avoid fire.

13. The electrical wiring inside the machine must not be changed at will. In the event of a malfunction, check

and repair in time, and non-professional maintenance personnel are not allowed to disassemble or replace

it without authorization.