SHP132 Vivitek Projector Bulb Replacement for D330MX D330WX

SHP132 Vivitek Projector Bulb Replacement for D330MX D330WX

Good Quality 5811116685-S Projector Bulb SHP132 Compatible For Vivitek D330MX D330WX

Vivitek projector lamp 5811116685-S (SHP132(220W)), compatible for D330MX D330WX . We are committed to offering an easy and safe Projector Bulb buying experience that brings enjoyable shopping experience to all our customers. Warranty does not cover: shipping costs, improper installation including damages incurred while attempting installation, any installation or labor costs, lamps damaged by TV projector malfunction, damage due to abuse, lightning or acts of nature, misuse, electrical stress or power surges, loss of use, lost profits.

Specifications:

Warm Noted:

Be sure to use an ELPLP85 Projector Lamp for replacement.

Be sure to turn off the unit and unplug the power cord before replacing the lamp

The lamp remains hot after the unit is turned off with the TV.

If you touch the lamp, you may burn your fingers. When you replace the lamp

Wait for at least 0.5 hour for the lamp to cool. Do not touch the surface of the lamp

If you touch it, wipe off the fingerprints with a soft cloth

If you want your Projector Lamps work longer, please Note:
1. Do not allow the projector to overheat; the primary cause of lamp failure is excessive temperature stress.
2. Allow the projector lamp to cool for at least 10 minutes after powering down, and never move the projector during this period or
while the lamp is on. The lamp is much more susceptible to damage while it is hot.
3. Operate your projector in a clean, relatively dust-free environment to prevent clogging of fans and air filters. These filters
should be cleaned regularly.
4. Allow plenty of space around the projector's fan or exhaust so excess heat can be dispersed properly.
5. Utilize the "economy mode" if it is available with your projector model and is appropriate for your situation. This mode decreases projector brightness but the lamp will last longer.
6. Never leave a projector in very hot or very cold environments, for example in a car on a summer or winter day.

Installation:

1. Turn off the Projector and unplug the AC power cord.

2. Loosen the screw on the lamp cover with a screwdriver, and then open the lamp cover.

3. Loosen the 2 screws on the lamp with the screwdriver. Hold up the handle, then pull the lamp straight out.

4. Hold the handle of the new lamp and push it in securely until it reaches the end, and then tighten the 2 screws.

5. Close the lamp cover, and then tighten the screws

6. Plug in the AC power cord.