1.68＂SM Wireline Pulling Tool SR QLS BLQJ Connection

1.68＂SM Wireline Pulling Tool SR QLS BLQJ Connection

Universal Pulling Tools Wireline Pulling Tool

I. Introduction 

An S type pulling tool is an outer pulling tool, which can grasp the shoulder of the outer fishing neck with

special fishing claw and move upward to release the claw, and which is divided into three types: SB, SM

and SS.

II. General Technical Parameters

Pay attention to the model of grasping distance when ordering goods, More customized parts are

available upon request

III. Structural features

The S-type pulling tool is composed of upper contact, outer cylinder, sleeve, pressing cap, main spring,

secondary spring, spring seat, fishing claw, shear pin, etc.

There are some grooves distributed uniformly on the outer cylinder; the fishing claw is installed on the groove

and shrunk under the function of secondary spring and spring seat; the mandrel is fixed in the outer cylinder

with shear pin; the main spring is installed in the stepped hole on the top of the outer cylinder and pressed

with the pressing cap; the upper connect is connected with the outer cylinder.

While fishing, the outer fishing neck will enter into the outer cylinder to drive the fishing claw to move up,

and then the fishing claw will splay under the function of the slope of outer cylinder and fishing claw; after

continuing to move the outer fishing neck up, the fishing claw will reset under the function of secondary

spring, and then grasp the out fishing neck immediately; at this moment, the upper contact, outer cylinder

and fishing claw connected with the top tool string are bearing the strength of the object to be fished at the

bottom. When the tool moves downward, the outer fishing neck will hold out against the mandrel to cut off

the shear pin; the mandrel will be pulled up under the function of main spring, and the big step of the mandrel

will pull the fishing tool to move up and splay to complete releasing.