1.5A Behavior Monitoring 4g LTE OBD Wifi Hotspot Gps Tracker

4g tracking device tracer car GPS SMS gsm tracker with Driving Behavior Monitoring

VT900-L Features:

1:  Small Design

dimension:65mm*61mm*26mm,

weight:105g, easy to hide.
2:  Support orientation without orientated server:

it can find out Real-time longitude and latitude, time and speed.

3:  By using public map software and entering longitude and latitude manually,

you can find out the real-time information of position.
4:  If the target you are inquiring about enters into an underground parking lot or other GPS blind area,

the tracker will inform you of the last orientation.

5:  Get absolute address by SMS

6:  Remote Engine-stop and Resume.

7:  tracking function by timing and frequency
8:  Remote reset by SMS & reset button on the device

Specifications

Standard Accessories

Applying directions:
Vehicle fleet/logistics/Vehicle rental

Product Appearance

Antenna Connection
Connect GSM antenna on the SMA connector labeled "GSM" and connect the GPS antenna on the SMA connector labeled
"GPS", also ensure that both antennas are tightened.
The GSM antenna can be hidden in any place away from the power supply and cannot be attached to the metal surface,
otherwise, it will affect the GSM signal strength.
GPS antenna is used to receive satellite signal in the sky and should be fixed to face the sky and can not be installed in a
a place with metal shielding.

Product use
1 Charge
For the first time using the VT900 G, please connect the DC (positive) and GND (ground) to the 12V or 24V power supply
for at least 2 hours to ensure sufficient power. After configuration and testing, install it on the vehicle.
2 Insert SIM Card
The device supports SIM cards of 2G and 3G networks;
Please ensure that the SIM card has sufficient balance, and has opened the GPRS function and obtained the correct APN
of the SIM card;
Please make sure that the PIN lock function of the SIM card has been turned off;
If you need to use the call to reply to the location information function, please make sure that the SIM card has caller ID
function;
a. Make sure the device is turned off before installing the SIM. Unscrew the front baffle screw and take out the PCBA

b. Insert SIM Card

c. Fit on PCBA and screw on the screw