BENTLY NEVADA 106765-10 Interconnect Cable for 330525 velomitor sensor

Bently Nevada LLC supplies connecting cables with military-type circular connectors. The cable connector

must be compatible with the 330525 Velomitor® Sensor connector. The 106765-AA cable assembly includes

a quick connect/disconnect connector and clamps to secure and seal the splashresistant boot. The cable

assembly comes with the top clamp secured in position and the bottom clamp looped around the boot. Use

a small screwdriver to open the clamps by prying the teeth of the clamps apart. Slide the boot back to reveal

the connector. This will allow the cable assembly to easily install on the transducer. Once the connector is engaged,

slide the boot down over the connector assembly and top of the transducer. The groove on the inside bottom of the

boot should fit neatly over the lip above the hex flats. The grooves on the outside of the boot at the

top and bottom indicate the placement of the clamps. Secure the clamps with pliers.