Med-tronic Lifepak LP20 Defibrillator W03 IrDA Assembly 3200926-004

Med-tronic Physio-Control Lifepak LP20 Defibrillator W03 IrDA Assembly 3200926-004

► Brief Introduction

The W03 IrDA Assembly is used to provide high-speed wireless communications to data management devices. The OEM W03 IrDA port supports IrDA version 1.1 communications with asynchronous serial rates up to 4 Mbits/second. The IrDA port is mounted directly on the bottom case and the flex circuit connects directly to the A01 System Control PCB at J08. An infrared lens is molded into the device front case directly in front of the IrDA port. The IrDA port and front case lens are aligned so that direct communications can easily be made with a portable data receiver held by an operator or placed on a table.

► To remove the W03 IrDA Assembly:

1. If the boardstack is not removed, disconnect the W03 IrDA flex cable from the A01 System PCB at J8 by first removing the screw using a 3/32 allen driver.
2. Insert a slotted screwdriver into the slot between the bottom case cutout (A) and the right snap tab (B).
3. Gently apply pressure to the screwdriver. Bend the right IrDA snap tab (B) outward slightly, freeing the right edge of the W03 IrDA Assembly.
4. Remove the W03 IrDA Assembly from the bottom case.
5. If the boardstack is still installed in the bottom case, disconnect the IrDA connector from PCB.

► To install the W03 IrDA Assembly:

• Position the W03 IrDA Assembly on the bottom case. (The IrDA is located near the center of the front panel on the bottom case.)
• Insert a large slotted screwdriver into the slot between the bottom case cutout (A) and the right snap tab (B).
• Gently apply pressure to the screwdriver. Bend the right IrDA snap tab (B) slightly outward,
• Press the W03 IrDA Assembly down into the snap tabs and release the pressure on the screwdriver. The snap tabs will close around the W03 IrDA Assembly.
• Ensure that the W03 IrDA Assembly is resting centered on the support brackets and snap tabs.
• Connect the W03 IrDA Assembly to the A01 System PCB and fasten with a screw using a 3/32 allen driver, if the boardstack is still installed in the bottom case. Otherwise, Install the boardstack. The IrDA flex cable is connected during the boardstack installation

► Specification

Thank you for your time and interest in Med-tronic Physio-Control Lifepak LP20 Defibrillator W03 IrDA Assembly 3200926-004. If you want to explore more details please let us know.