PSH Semi Automatic Parking System Lift 2000kg Multi Layer

Product overview

Puzzle parking system is a semi-automatic mechanical stereoscopic parking equipment. It can be built in the open air or under the building. It can be divided into whole ground layout, half underground layout, recolumn layout, etc. PSH puzzle parking system can be divided into wire rope lifting type, chain lifting type, hydraulic cylinder lifting type, screw lifting type, combined lifting type, etc. Multi-layer lifting and transversal parking garage adopts roller, pulley and steel wire rope for lifting. In the whole mechanism, there are ac decelerating transversal motor and lifting motor, steel wire, transversal frame, transversal guide rail and so on. Its operation principle is to take the upper car, the lower load plate horizontal move out of the empty parking space.The lower level of the parking equipment is left and right transverse, and the top level is up and down.

Characteristics

• This parking equipment is simple in structure, convenient in operation, easy to maintain and repair.
• Short construction cycle, low construction cost, strong adaptability to the site, low requirements for civil construction, can be built in the open air, can also be built in the underground of the building, the scale can be large or small, according to different terrain and space for any combination, arrangement, high space utilization rate, safe and reliable equipment, fast access car.
• When it is working, there should be exchange parking space, that is, empty parking space.Therefore, the calculation of the effective parking number is not a simple superposition of the number of parking Spaces on the ground and the number of floors.Usually the larger garage is divided into a number of units, a unit can only be stored and taken by one person first or later, not two or more people at the same time.Therefore, if the unit is divided too large, it will reduce the efficiency of storing and taking cars;Too small a division will reduce the number of parking spaces and reduce the use of land.Based on experience, a unit responsible for 5 to 16 cars is appropriate.
• The lifting and horizontal mechanical parking equipment has the following safety devices: emergency stop switch, prevent overrunning device, vehicle length, width, height limit device, vehicle blocking device, vehicle error detection device, vehicle position detection device on the vehicle board, prevent vehicle board falling device and warning device, etc.

What is the dimension of semi-automated parking system

The height of the entrance and exit of the semi-automatic mechanical parking equipment should be no less than 1700 mm. The height of the passage for people inside the parking equipment should be no less than 1700 mm. The width of the passage should be increased by more than 500 mm on the basis of suitable parking vehicle width.

Generally, there are 2 layers,3 layers,4 layers,5 layers,6 layers,7 layers,8 layers and other types.

Technical Parameters