R5F566NNDDBD#20 RXv3 RX66N R5F566 Renesas MCUs Microcontroller IC 32 Bit

RXv3 RX66N series Microcontroller IC 32-Bit FLASH 224-LFBGA R5F566NNDDBD#20

RXv3 series Microcontroller IC 32-Bit 120MHz 4MB (4M x 8) FLASH 224-LFBGA (13x13)

IC MCU 32BIT 4MB FLASH 224LFBGA

Applications:

■ AC servo driver

■ General-purpose inverter

■ PLC (Programmable Logic Controller)

■ Industrial robot

■ Motion controller

■ Remote I/O

■ HVAC controller

■ Smart meter

■ Smart speaker

RXv3 Series :

120-MHz 32-bit RX MCU, on-chip double-precision FPU, 698 CoreMark, up to 4-MB flash memory (supportive of the dual bank function), 1-MB SRAM, various communications interfaces including Ethernet MAC, SD host interface, quad SPI, and CAN, 12-bit A/D converter, RTC, Encryption functions (optional), Serial sound interface, CMOS camera interface, Graphic-LCD controller, 2D drawing engine.

Features

■ 32-bit RXv3 CPU core

 Maximum operating frequency: 120 MHz Capable of 698 CoreMark in operation at 120 MHz

 Double-precision 64-bit IEEE-754 floating point

 A collective register bank save function is available.

 Supports the memory protection unit (MPU)  JTAG and FINE (one-line) debugging interfaces

■ Low-power design and architecture

 Operation from a single 2.7- to 3.6-V supply

 RTC is capable of operation from a dedicated power supply.

 Four low-power modes

■ On-chip code flash memory

 Supports versions with up to 4 Mbytes of ROM

 Read cycle of 8.3 ns in operation at 120-MHz with no access wait cycles

 User code is programmable by on-board or off-board programming.

 Programming/erasing as background operations (BGOs)

 A dual-bank structure allows exchanging the start-up bank.

■ On-chip data flash memory

 32 Kbytes, reprogrammable up to 100,000 times

 Programming/erasing as background operations (BGOs)

■ On-chip SRAM  1 Mbyte of SRAM (no wait states)

 32 Kbytes of RAM with ECC (single error correction/double error detection)

 8 Kbytes of standby RAM (backup on deep software standby)

■ Data transfer  DMACAa: 8 channels

 DTCb: 1 channel

 EXDMAC: 2 channels

 DMAC for the Ethernet controller: 1 channel

■ Reset and supply management

 Power-on reset (POR)

 Low voltage detection (LVD) with voltage settings

■ Clock functions

 External crystal resonator or internal PLL for operation at 8 to 24 MHz

 PLL for specific purposes

 Internal 240-kHz LOCO and HOCO selectable from 16, 18, and 20 MHz  120-kHz clock for the IWDTa

■ Real-time clock

 Adjustment functions (30 seconds, leap year, and error)

 Real-time clock counting and binary counting modes are selectable

 Time capture function (for capturing times in response to event-signal input)

■ Independent watchdog timer  120-kHz clock operation

■ Useful functions for IEC60730 compliance

 Oscillation-stoppage detection, frequency measurement, CRCA, IWDTa, self-diagnostic function for the A/D converter, etc.

 Register write protection function can protect values in important registers against overwriting.

Various communications interfaces

 Ethernet MAC (1 channel)

 PHY layer (1 channel) for host/function or OTG controller (1 channel) with full-speed USB 2.0 transfer

 CAN (compliant with ISO11898-1), incorporating 32 mailboxes (up to 3 channels)

 SCIj and SCIh with multiple functionalities (up to 8 channels) Choose from among asynchronous mode, clock-synchronous mode, smart-card interface mode, simplified SPI, simplified I2C, and extended serial mode.

 SCIi with 16-byte transmission and reception FIFOs (up to 5 channels)

 I2C bus interface for transfer at up to 1 Mbps (3 channels)

 Four-wire QSPI (1 channel) in addition to RSPIc (3 channels)

 Parallel data capture unit (PDC) for the CMOS camera interface (except for 100-pin products)

 Graphic-LCD controller (GLCDC)

 2D drawing engine (DRW2D)

 SD host interface (1 channel) with a 1- or 4-bit SD bus for use with SD memory or SDIO

 MMCIF with 1-, 4-, or 8-bit transfer bus width ■ External address space

 Buses for full-speed data transfer (max. operating frequency of 80 MHz)

 8 CS areas

 8-, 16-, or 32-bit bus space is selectable per area

 Independent SDRAM area (128 Mbytes)

■ Up to 29 extended-function timers

 32-bit GPTW (4 channels)

 16-bit TPUa (6 channels), MTU3a (9 channels)

 8-bit TMRa (4 channels), 16-bit CMT (4 channels), 32-bit CMTW (2 channels)

■ 12-bit A/D converter  Two 12-bit units (8 channels for unit 0; 21 channels for unit 1)

 Self diagnosis, detection of analog input disconnection

■ 12-bit D/A converter: 2 channels

■ Temperature sensor for measuring temperature within the chip

■ Encryption functions (optional)  AES (key lengths: 128, 192, and 256 bits)

 Trusted Secure IP (TSIP)

■ Up to 182 pins for general I/O ports

 5-V tolerance, open drain, input pull-up, switchable driving ability

■ Operating temp. range

 D-version: –40C to +85C  G-version: –40C to +105C

Flash Memory: 4MB, SRAM: 1MB With Trusted Secure IP

Flash Memory: 2MB, SRAM: 1MB

Related Popular Microcontrollers IC:

RX66N,R5F56 6N NDDBD,R5F566NNDDFC,R5F566NNHDFC,R5F566NDDDFC,R5F566NDHDFC,R5F566NNDDFB,R5F566NNHDFB,R5F566NDDDFB,R5F566NDHDFB,R5F566NNDDFP,R5F566NNHDFP,R5F566NDDDFP,R5F566NDHDFP,R5F566NNDDBD,R5F566NNHDBD,R5F566NDDDBD,R5F566NDHDBD,R5F566NNDDBG,R5F566NNHDBG,R5F566NDDDBG,R5F566NDHDBG,R5F566NNDDLK,R5F566NNHDLK,R5F566NDDDLK,R5F566NDHDLK,R5F566NNDGFC,R5F566NNHGFC,R5F566NDDGFC,R5F566NDHGFC,R5F566NNDGFB,R5F566NNHGFB,R5F566NDDGFB,R5F566NDHGFB,R5F566NNDGFP,R5F566NNHGFP,R5F566NDDGFP,R5F566NDHGFP,R5F566NDDBD,R5F566NNDGBD R5F566NNDDBD#20--- LPC1788FBD208
R5F566NNDDFP#30 ---- LPC1763FBD100

RX66N MCU GROUP-Outstanding Real-Time Performance:

This 32-bit microcontroller is ideal for real-time applications such as general-purpose inverters and IoT gateways. RX66N delivers outstanding real-time performance with the RXv3 core operating at 120MHz and has industry's largest and fastest class on-chip memory. Hence, RX66N supports various functions such as HMI, networking, and security required for industrial and consumer equipment on a single chip, contributing to smaller enclosure and shortened development time.

Features:

120MHz RXv3 core, Double-precision FPU, Register bank save function accelerating interrupt response

■ 4MB flash memory (120MHz read access, Dual bank function), 1MB SRAM

■ 182 general-purpose input/output (GPIO) ports

■ Ethernet, SD host I/F, USB 2.0 full speed, 3ch CAN, QSPI

■ TFT LCD controller supporting WVGA, 2D drawing engine, Serial sound I/F, CMOS camera I/F

■ Encryption engine (AES, TDES, RSA, ECC, SHA, TRNG), Key management, Flash memory protection function

Environmental & Export Classifications