70 Pcs/Min 140-350g/M2 Craft Paper Bowl Making Machine PLC Control

Features of 70pcs speed paper bowl making machine

• inclined frame, paper bowl dropping rate 99.99%
• mould plate, nylon wheel, chassis are all made by aluminum, it is light, good anti turntable inertia with long life and more durable than other iron machine
• Full automatic, Easy changing molds produce different sizes paper bowls
• Easy operating, save labor cost (one operator is enough)
• Cheap operating cost and low investment

♦Detail♦

Repeatedly loose paper

Three paper feeds and multiple mediations to avoid unevenness on both sides of the paper cup.

Photoelectric Sensor Detection

The encoder and the Photoelectric Sensor control the machine at the same time, a fan-shaped plate with a cup bottom to avoid paper waste. Failure alarm, automatic shutdown.

PLC control

The machine is more intelligent, the control is more precise, and the labor is greatly reduced.

Multiple cooling fans

Multiple cooling fans operate at the same time to increase heat dissipation and speed up cooling, ensuring that the machine works at an appropriate temperature.

Multiple cooling fans

Multiple cooling fans operate at the same time to increase heat dissipation and speed up cooling, ensuring that the machine works at an appropriate temperature

Automatic oil lubrication system

The machine automatically lubricates each part that needs to be lubricated through the copper pipe, which greatly saves labor

Waste paper transportation

Guided by the conveyor belt, the waste paper is discharged. Prevent waste paper from being transferred into the machine when the machine is operating, it is not easy to clean up, and affect the work of the machine

Sheave drive

The inside of the machine is connected by groove wheels, and the parts are more tightly connected. It is not easy to loosen during the operation of the machine and the work is more accurate

Bottom punching system

In the past, the complicated paper feeding process of the bottom suction paper was prone to overturning. After improving the equipment, the direct bottom punching method was used to avoid the bottom turning in one step.

♦Technical Specification♦