Anodized Metal Edge Trim For Wall Tile 2mm Thickness Anti Collision

Tile Corner Protection Aluminium Panel Trim Wall UV Board Decoration
 

Application
 

A. Select one of the following finish options

1. Anodized Finish:

a. COLOUR - Satin Clear 10 / ALUMINUM ASSOCIATION SPECIFICATION - AA-M12C22A31 /

ANODIZING DESCRIPTION: Architectural Class II - Minimum 10μ (0.4 mil) coating

b. COLOUR – Black 18 / ALUMINUM ASSOCIATION SPECIFICATION - AA-M12C22A44 /

ANODIZING DESCRIPTION: Architectural Class II - Minimum 18μ (0.7 mil) coating

B. Primed Finish:

1. Primer – Oven baked, PPG Duracon 100 Beige Primer.

2. For site paint application with high-quality acrylic latex paint or factory pre-finished with high-quality

acrylic latex paint or powder coat

C. ColorMatch® Pre-Finished Custom Color:

1. Factory applied high-quality acrylic latex paint

2. Air dried and cured


Feature

Paint & Powder Coating: BS 6496 (1984)

Specification for powder organic coatings for application and stoving to aluminium alloy extrusions,sheet and pre-formed sections for external architectural purposes, and for the finish on aluminium alloy extrusions, sheet and preformed sections coated with powder organic coatings.

Use
 

Polyester powder coated finish External applications Fusion bonded polyester powder coated surfaces will enjoy many years of good service if regularly maintained. For external applications, suggested cleaning intervals will vary between once every three months in harsh industrial or marine environments and up to once yearly in rural atmospheres. After removing any grease or oil deposits with a white spirit solution, use a mild diluted detergent to wash over and rinse with cold clean water. Dry off with a soft cloth. Abrasive cleaning agents or materials should not be used as surface scratching may occur. Internal applications After initial cleaning a regular wipe over with a soft cloth, to remove finger and dirt deposits, is all that is normally required to maintain good surface appearance.

Specification