Six Functions Woodworking Edge Bander MDF PVC Plywood Edge Banding Machine

The automatic linear edge banding machine mainly consists of functions such as preheating, gluing, welting, front and rear alignment, upper and lower trimming, and upper and lower polishing.
1. Preheating: a function of heating the board before gluing, in order to stick it more firmly with the edge band after gluing.
2. Gluing: Through the special structure, the edge-sealing plate and the edge-sealing material are evenly glued on both sides to ensure stronger adhesion.
3. Welt: Paste the edge band on the plate by pressing the roller and press it tightly.
4. End trimming: Cut off the excess edge banding on the front and back of the plate after welting, so that the edge banding and the end face of the plate are flat.
5. Trimming: Trimming is a function including rough trimming, fine trimming, profiling trimming, and edge scraping. The edge of the board is smooth and round, so that it can beautify.
6. Polishing: Use the polishing wheel of soft material to throw the working surface glossy to achieve better effect.

PLC intelligent control, independent liquid crystal display can see the running process of the machine more clearly and comprehensively, which is convenient, quick and easy to use, real-time monitoring, real-time adjustment, more accurate, high-efficiency production, and the edge sealing effect is not compromised.

The edge-sealing gluing device heats the sol through the gluing pot, and adopts the spiral structure to deliver the glue. The gluing speed is fast, uniform, and the adhesive force is firm.

The end trimming device, through the structure of automatic mold tracking and high-frequency high-speed motor, ensures that the cut surface is smooth and smooth, and has the protection function of flushing the plate to enhance the stability of the flush.

Rough trimming device, the cutter at the rough trimming part is a flat knife, which is used to trim the excess edge sealing material on the upper and lower parts of the edge banding of the processed sheet.

Finishing device, the finishing knife is R2 inclined knife, which can leave 5-6 wire allowance for the next scraping process. The automatic tracking of the mold and the high-frequency motor are used to achieve fast cutting, and the R2 inclined knife is used to repair the radian.

Scraping device, profile scraping, is used to eliminate the secondary wave marks caused by the cutting process of non-linear motion of trimming, so that the upper and lower parts of the plate are more smooth and tidy. better.

The polishing device cleans the processed plate with a cotton polishing wheel, removes excess glue stains, and makes the edge banding section smoother and tidy through polishing.