Mellanox MC2210411-SR4E Compatible Transceiver QSFP+ MMF 400M
MPO/MTP-12 850NMParameters| Data Speed | 40Gbps | | Center Wavelength | 850NM | | Fiber Type | Multimode | | Transmission | 300m via OM3, 400m via OM4 | | Connector | MPO/MTP | | Lasers | VCSEL + PIN | | Tx power | -7.5 - 0 dBm | | Rx sensitivity | <-9.9 dBm | | Extinction Ratio | 3 dB | | Power Consumption | < 1.5 W | | Single Power Supply | 3.3 v |
Top-Trans QSFP+-40G-XSR4 is a 40GBASE-XSR4 transceiver
equivalent to Mellanox MC2210411-SR4E, compatible with the Mellanox MSN2100 Series Switch and
MCX516A-BDAT NIC. This XSR4 transceiver is similar to the SR4
transceiver, but provides an extended 400M fiber link and
enables a wide range of LAN connections for data
center and enterprise infrastructure.This QSFP+ module features the parallel Quad Small Form-Factor
Pluggable (QSFP) with four independent 850NM
VCSEL transmitters and PIN receivers. This QSFP
module creates the data link of 40GBASE-SR4 over a 300 meters OM3
multimode fiber (400 meters via OM4). This QSFP+ Module
features an MPO/MTPTM connector for the latest 8 cores new cabling system. This
QSFP+ Module supports 40G to 4x10G Breakout Application with MTP/MPO to 4x10G LC cable. This QSFP+ module is fully compliant with IEEE 802.3by, IEEE 802.3cc, SFF-8402,
SFF-8472, 21CFP-1040 LC#50 7/2001. It features build-in
DDM/DOM via the I2C Interface to monitor the operating status. Key Features4 independent full-duplex channelsUp to 11.2Gbps data rate per channelMTP/MPO optical connectorQSFP MSA compliantDigital diagnostic capabilitiesCapable of over 100m transmission on OM3 multi-mode ribbon fiberCML compatible electrical I/OSingle +3.3V power supplyOperating case temperature: 0~70CXLPPI electric interface (with 1.5W Max power)RoHS-6 compliant
Protocol
FAQ - What Mellanox equipment do you use for the compatibility test?
Mellanox MCX516A-BDAT NIC
Yes, this QSFP+ Module can support Infiniband QDR protocolWhat else SFP do you provide?
Topstar is an integrated SFP transceiver solution provider, with a
reliable supply chain todistribute brand original cisco, Finisar, brocade, innolight,
dell-EMC, Avago, source etc transceiverand joint factory to do OEM for 10G to 400G bandwidth Optical
Transceiver. If we need a longer fiber link than 400m, can you
provide better optics?
Yes, you can check our QSFP+ MPO 2KM, 10KM and LC 2KM, 10KM
optics |
