MIL-STD-810F Battery Hydraulic Mechanical Shock Testing Machine

MIL-STD-810F Battery Hydraulic Mechanical Shock Testing Machine

Complied Standards & Clauses

The equipment meets the test specifications of MIL-STD-202F, IEC-68-2-27, MIL-STD-810F, MIL-STD-883E, etc.

Product Overview

This shock test machine is designed for evaluating the mechanical robustness and structural integrity of products under impact conditions. It is widely used in fields such as electronics, aerospace, military, automotive components, shipping, and transportation. By configuring different waveform generators, it can perform a variety of shock tests including half-sine wave, post-peak sawtooth wave, and square wave simulations.

Environmental requirements:
1. On-site temperature: 5℃~+28℃ (average temperature within 24 hours ≤28℃);
2. Relative humidity: ≤ 85% RH;
3. Air source: 0.5--0.8MPa
4. Power supply conditions: three-phase five-wire;
5. Voltage range: AC380V;
6. Allowable frequency fluctuation range: (50±0.5)Hz;
7. The grounding resistance of the protective ground wire is less than 4Ω;
8. The user is required to configure an air or power switch of corresponding capacity for the equipment at the installation site, and this switch must be used independently for this equipment.

Technical Parameters