IEC 62196 Fig12 Electric Vehicle Charging Gun Terminal Testing Equipment

IEC 62196 Fig12 Electric Vehicle Charging Gun Terminal Testing Equipment

Complied Standards & Clauses

This testing machine conforms to IEC 62196-1:2020 clause 13.3.1 fig12, table 3, and UL486A-B:2009clause 9.3.2.1,clause 9.3.2.3,clause 9.3.2.4 and table 26 and figure 6 etc.

Technical Parameters

Equipment Overview

This device tests whether threaded terminals and unthreaded terminals can withstand the mechanism stress during normal use. It is mainly used to judge whether the design and structure of the thread clamping terminal meet the requirements of the clamping wire without excessive damage.

It adopts guide screw structure. When used, the number of tests can be preset first, and the set value will automatically stop, and accompanied by sound alarm signal.

The number of tests can be preset before the test. When the preset number of tests is reached, the testing machine automatically stops and an alarm is issued.

Q: What is the diameter of bushing hole for this device?
A: It is 6.5mm, 9.5mm, 13mm, 14.5mm, 15.9mm, 19.1mm, 22.2mm, 25.4mm, 28.6mm, 31.8mm, 38.1mm, 44.5mm (details refer to following table 3).

Q: What is the Rate of Testing for this device?
A: It is (10±2) r/min.

Details: