EN 1.4319 EN ASTM JIS 301 Stainless Steel Plate 0.4-30mm

EN 1.4319 Stainless Steel Sheet & Plate EN ASTM JIS 301 Stainless Steel Thickness 0.4 - 30.0mm Thickness

Specification of our EN 1.4319 Stainless Steel Plate

EN 1.4319 stainless steel is an austenitic stainless steel formulated for primary forming into wrought products. Cited properties are appropriate for the solution annealed (AT) condition. 1.4319 is the EN numeric designation for this material. X5CrNi17-7 is the EN chemical designation.

It has a fairly high ductility among wrought austenitic stainless steels. In addition, it has a moderately low embodied energy and a moderately low base cost.

The graph bars on the material properties cards below compare EN 1.4319 stainless steel to: wrought austenitic stainless steels (top), all iron alloys (middle), and the entire database (bottom). A full bar means this is the highest value in the relevant set. A half-full bar means it's 50% of the highest, and so on.

Stainless steel 1.4319 Chemical composition

Chemical composition

Stainless steel 1.4319 Mechanical Properties:

EN1.4319 Stainless Steel Sheet maintenance:

(1) Regular cleaning and maintenance

(2) Pay attention to prevent the occurrence of the phenomenon of surface scratches

(3) Use soap, weak detergent or warm water to remove surface dust, dirt

(4) In addition to the surface of the binder with alcohol or an organic solvent (ether, benzene)

(5) Use neutral detergent or ammonia solution in addition to surface oil

(6) With 10% nitric acid or abrasive detergent in addition to the surface of the embroider caused by dirt.

Products Show