PIC12C508AT-04I/SN Microchips And Integrated Circuits 8- Bit CMOS Microcontrollers

PIC12C508AT-04I / SN Microchips And Integrated Circuits 8- Bit CMOS Microcontrollers

PIC12C5XX

8-Pin, 8-Bit CMOS Microcontrollers

Devices included in this Data Sheet:

• PIC12C508          • PIC12C508A         • PIC12CE518

• PIC12C509          • PIC12C509A         • PIC12CE519

• PIC12CR509A

Note: Throughout this data sheet PIC12C5XX refers to the PIC12C508, PIC12C509, PIC12C508A, PIC12C509A, PIC12CR509A, PIC12CE518 and PIC12CE519. PIC12CE5XX refers to PIC12CE518 and PIC12CE519.

High-Performance RISC CPU:

• Only 33 single word instructions to learn

• All instructions are single cycle (1 µs) except for program branches which are two-cycle

• Operating speed: DC - 4 MHz clock input

                               DC - 1 µs instruction cycle

• 12-bit wide instructions

• 8-bit wide data path

• Seven special function hardware registers

• Two-level deep hardware stack

• Direct, indirect and relative addressing modes for data and instructions

• Internal 4 MHz RC oscillator with programmable calibration

• In-circuit serial programming

Peripheral Features:

• 8-bit real time clock/counter (TMR0) with 8-bit programmable prescaler

• Power-On Reset (POR)

• Device Reset Timer (DRT)

• Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation

• Programmable code-protection

• 1,000,000 erase/write cycle EEPROM data memory

• EEPROM data retention > 40 years

• Power saving SLEEP mode

• Wake-up from SLEEP on pin change

• Internal weak pull-ups on I/O pins

• Internal pull-up on MCLR pin

• Selectable oscillator options:

  - INTRC: Internal 4 MHz RC oscillator

  - EXTRC: External low-cost RC oscillator

  - XT: Standard crystal/resonator

  - LP: Power saving, low frequency crystal

CMOS Technology:

• Low power, high speed CMOS EPROM/ROM technology

• Fully static design

• Wide operating voltage range

• Wide temperature range:

  - Commercial: 0°C to +70°C

  - Industrial: -40°C to +85°C

  - Extended: -40°C to +125°C

• Low power consumption

  - < 2 mA @ 5V, 4 MHz

  - 15 µA typical @ 3V, 32 KHz

  - < 1 µA typical standby current

GENERAL DESCRIPTION

The PIC12C5XX from Microchip Technology is a family of low-cost, high performance, 8-bit, fully static, EEPROM/EPROM/ROM-based CMOS microcontrollers. It employs a RISC architecture with only 33 single word/single cycle instructions. All instructions are single cycle (1 µs) except for program branches which take two cycles. The PIC12C5XX delivers performance an order of magnitude higher than its competitors in the same price category. The 12-bit wide instructions are highly symmetrical resulting in 2:1 code compression over other 8-bit microcontrollers in its class. The easy to use and easy to remember instruction set reduces development time significantly.

The PIC12C5XX products are equipped with special features that reduce system cost and power requirements. The Power-On Reset (POR) and Device Reset Timer (DRT) eliminate the need for external reset circuitry. There are four oscillator configurations to choose from, including INTRC internal oscillator mode and the power-saving LP (Low Power) oscillator mode. Power saving SLEEP mode, Watchdog Timer and code protection features also improve system cost, power and reliability.

The PIC12C5XX are available in the cost-effective One-Time-Programmable (OTP) versions which are suitable for production in any volume. The customer can take full advantage of Microchip’s price leadership in OTP microcontrollers while benefiting from the OTP’s flexibility.

The PIC12C5XX products are supported by a full-featured macro assembler, a software simulator, an in-circuit emulator, a ‘C’ compiler, fuzzy logic support tools, a low-cost development programmer, and a full featured programmer. All the tools are supported on IBM PC and compatible machines.

Absolute Maximum Ratings†

Ambient Temperature under bias................................................................................ –40°C to +125°C

Storage Temperature ................................................................................................  –65°C to +150°C

Voltage on VDD with respect to VSS .....................................................................................0 to +7.5 V

Voltage on MCLR with respect to VSS.................................................................................... 0 to +14 V

Voltage on all other pins with respect to VSS .................................................... –0.6 V to (VDD + 0.6 V)

Total Power Dissipation(1) .........................................................................................................700 mW

Max. Current out of VSS pin ........................................................................................................200 mA

Max. Current into VDD pin ...........................................................................................................150 mA

Input Clamp Current, IIK (VI < 0 or VI >VDD) ............................................................................... ±20 mA

Output Clamp Current, IOK (VO < 0 or VO > VDD)...................................................................... ±20 mA

Max. Output Current sunk by any I/O pin........................................................................................25 mA

Max. Output Current sourced by any I/O pin...................................................................................25 mA

Max. Output Current sourced by I/O port (GPIO) ......................................................................... 100 mA

Max. Output Current sunk by I/O port (GPIO )................................................................................100 mA

Note 1: Power Dissipation is calculated as follows: PDIS = VDD x {IDD - ∑ IOH} + ∑ {(VDD-VOH) x IOH} + ∑(VOL x IOL)

†NOTICE: Stresses above those listed under "Maximum Ratings" may cause permanent damage to the device. This is a stress rating only and functional operation of the device at those or any other conditions above those indicated in the operation listings of this specification is not implied. Exposure to maximum rating conditions for extended periods may affect device reliability.

PIC12C5XX BLOCK DIAGRAM