Light Gauge High Speed Precision Slitting Line 0.3-3 X 1250

Hot Sale Precision Slitting Line for Light Gauge (0.3-3 X 1250)

Light Gauge sheet slitting line have hot sale model, 0.3-3 X 1250, slitting speed usually 120m/min,mechanism is arranged to reduce down time, the time of loading, threading and unloading for a coil can be finished in 10minutes. generally15T coil needs 30-40minutes, each day 8hours can produce 200T.

light gauge metal high speed high precision Slitting line has characteris of precisely designed, machined, assembled and installed, we supplied 3 x 1250 slitting lines to Russia(2sets), Kazakhstan(2sets), Costa Rica(1set), El Salvador(1Set), Colombia(1set), Tanzania (1set), Nigeria(1set), Philippines(2sets), etc..

Composition and layout

Coil preparing saddle, Coil loading Car, Uncoiler, Coil head Opener, Pinch feeder & Pre-leveler, Shear, Pit accumulator 1, Entry guide, Slitter, Scrap winder, Pit Accumulator 2, Tensioner and Pre-separator, post shear and deflector roller, recoiler with overarm separator, coil discharging car, (turnstile)

• 1.Coil storing saddle: put coil ready on the saddle, coil car come under the coil and lift it up
• 2.Coil loading car: either floor type coil car or pit type, load coil onto uncoil mandrel.
• 3.Single mandrel uncoiler: hydraulic expansion mandrel for standard Ф508mm, and can install additional segments or rubber sleeve to uncoil bigger ID coils.
• 4.Coil head press roller, peeler shoveling plate: to open coill head and send the head into pinch feeder.
• 5.Pinch feeder, 3rolls Leveler, front shear: in threading send coil head forward to slitter, in automatic mode, synchronous with slitter continuously sending strip into 1# accumulator loop.
• 6.1# accumulator loop: hydraulic flapping plate as bridge to let thin sheet pass over during threading stage, in automatic mode, accumulate steel trip in loop pit to synchronize pinch feeding and slitting speed.
• 7.Press rollers and side guide: to horizontally and vertically guide steel strip on center of slitter.
• 8.Slitter: include a pair of parallel knife shafts, one moveable slitter stand, one fixed slitter stand, screw down mechanism, motor and transmission as well as high precision slitting tools.
• 9.Edge scrap winder: wind up edge scrap, winding tension is provided by motor controlled by inverter.
• 10.2# accumulator loop pit: the same structure with 1# accumulator pit, to guarantee synchronous speed of slitting and recoiling, the slit strips never ever entangle in the loop.
• 11.Press rollers, Tension, post shear: press slit strips, hydraulic wool felt type or roller type tension provision of recoiling,cut strip tails flat.
• 12.Pre separator and Deflector roller: before recoiling, separate steel strips in order and deflect strips to recoil mandrel gripper.
• 13.Separating overarm and recoiler: either seamless or open segments mandrel, coil strips up neatly.
• 14.Coils Unloading Car: unload slit coils from recoil mandrel.
• 15.Hydraulic System: hydraulic power pack, valves, pipes and joints
• 16.Electric control system: Siemens PLC to control the slitting line working.

Parameters

Layout Drawing