DS200DTBAG1AAA GE Digital Contact Terminal Board Mark V Ge Turbine Control

DS200DTBAG1AAA GE Digital Contact Terminal Board Mark V Ge Turbine Control

Product Details:

Produced by General Electric as part of the Mark V series, the Digital Contact Terminal Board DS200DTBAG1AAA features two terminal blocks

that connect a maximum of 95 wires. This unit also features five jumpers and two 2-pin connectors. The terminal blocks attach signal wires that

send and receive information used by the drive. The potential is for a maximum of 190 wires attached to the GE Digital Contact Terminal Board

DS200DTBAG1AAA, so you must be aware of the damage that can be caused to the other components and boards. A screwdriver is used to

loosen the terminal to remove the wires meaning it might hit or scratch other components when uninstalling. To prevent that, use one hand to

guide the screwdriver to the terminal you want to loosen.

As you remove the signal wires from the DS200DTBAG1AAA, try to move them to one side and out of the way of the other boards. If possible,

reinstall the signal wires before you install the replacement board to limit the opportunity to damage the fragile boards in the drive. If you can

attach the wires, hold the board from the sides only and use two hands. Carefully maneuver the board into the cabinet and align the holes with the

holes in the rack where you will install the board. When you perform the replacement, it is necessary to wear a wrist strap and have the end of the

strap attached to a metal structure that is not painted.