Features:
- Brand New and High quality.
- Designed for the attachment of a wide variety of automotive
exterior and interior trim including body side moldings, claddings,
rock panel trim, wheel flares, bumper trim and most other
automotive trim/Home Decorations.
- Strong adhesion to automotive substrates.
- Weather and car wash resistant.
- Confortable. Can be used on textured surfaces, such as painted
cement or brick.
- High-strength core maintains a thin, consistent bond line.
- Perfect to use on LED strip mounting at indoor or outdoor
(included bathroom).
How to use this tape?
Clean: For maximum bond strength,the surface must be clean, dry,
smooth, have no rust and oil pollution.Typical cleaning solvents
are heptane or isopropyl alcohol.
Pressure: Pressure on the adhesive and the surface can help improve
bond strength, roller or platen can be used.
Time: After application, the bond strength will increase as the
adhesive flows onto the surface. At room temperature approximately
50% of ultimate bond strength will be achieved after 20 minutes,
90% after 24 hoursand 100% after 72 hours.
Temperature:Ideal application temperature range is 70°F to 100°F
(21degree centigrade to 38degree centigrade).Operating temperature
should not be below 10 degree centigrade, the temperature is too
low, will lead to cure time longer. If temperature is too low, move
material and adhesive tape into the warm indoor storage or heating
treatment.
| | |
Adhesion to Steel | ≧42N/25mm | GB/T 2792 -2014 |
Holding power | ≧24H | GB/T 4851-2014 |
Total Thickness(W/O liner) | 1.0mm | GB/T 7125-2014 |
Temperature Use Range | ≧320°F (160°C) | Short time 4H Static 100g hang |
Temperature Use Range | ≧248°F (120°C) | Long time 10000min Static 250g hang |
