| Table Type Pneumatic Hot Melt Equipment Model:BY-3025RR(QD) |
|
| Item | Detailed Information |
|
| Equipment Introduction | ◆This equipment has been applied to the hot melt riveting of shell
products, the equipment can be welded from two different directions
at the same time.The total number of riveting points is 4, and the
temperature is controlled by region. |
| ◆ 10 sets of welding programs can be pre-stored, and the data
interface can run in tandem with the production line. |
| ◆ Japan MISUSI original heating device. Hot plate temperature
control, with self-test, closed-loop control, multi-point
independent temperature control, temperature control accuracy up to
±2 degrees. |
| ◆Equipped with man-machine interface and Chinese and English
bilingual interface operation. |
| ◆The cooling system is air-cooled by blowing air. |
| ◆Production cycle time25S-40S. |
| Equipment Features | Man-Machine Engineering | ◆Safety: the machine is equipped with protective grating and scald
warning safety baffle. |
| ◆Permission management: device setting administrator and operator
permissions. |
| ◆The work table height is 750MM(Sitting position) |
| ◆The quipment starting mode: The equipment is started by pushing
two starting buttons together with two hands. |
| Equipment capability/Quality traceability | ◆The device has the protection function of misoperation(the machine
will not work if the machine is not operated according to the
standard operation procedures). |
| ◆Production records:The equipment can meet customer requirements
for recording and storage of product capacity. |
| ◆Alarm failure and code recording:The equipment automatically
displays the alarm fault code and records it automatically |
| ◆Man-machine interface - visual information of man-machine
interface includes current operation steps, alarm information and
solutions. |
| ◆IMS interactive function: support Ethernet communication. The
equipment has the function of QR Code scanning and identification.
The data of hot plate temperature, displacement and time can be
recorded and sent to the company's IMS system. (This function is
customized according to customer requirements.) |
|
| Electrical layout/Safety | ◆The equipment is equipped with tooling identification sensor. If
the tooling model is wrong, the system will alarm and lock the
equipment. |
| ◆Locking function: in case of equipment failure or clamp
installation error, the product is locked to the corresponding
station (it needs to be unlocked by the designated personnel). |
| ◆Equipment alarm: when the equipment fails, the man-machine
interface displays alarm information, and the control system locks
the machine. |
| ◆Control system voltage DC24V. |
| ◆I/O- each station has a 10% I/O allowance for future expansion. |
| Technical Parameters | ◆Equipment demension(L)460MM*(W)400MM*(H)900MM. |
| ◆Maximum allowable die size of equipment(L)300MM*(W250MM*(H)250MM. |
| ◆Electric power requiement: 3 phases 380V 50Hz(If there are special
requirements, customer confirmation is required.). |
| ◆The outlet pressure of the air compressor:
4Kg/cm2-6Kg/cm2(约0.4MPA-0.6MPA). |
| ◆Adaptable to ambient temperature: -5℃～４0℃ |
| ◆Adaptalbe to humidity : ２０％～８０％ |
| ◆The noise of the transmission part shall not exceed 70 db. |
