Function
module | Operation | Keyboard and mouse can finish all operations |
X-ray tube
control | Using mouse to click the X button can turn on or off the X-ray.The
real-time tube voltage and current value will display beside,users
can click up and down button,or drag the slider,or type to adjust. |
| Status bar | Indicates the interlock status,pre-heat status,andX-ray status by
flashing alternately red and green. |
Image effect
adjustment | The brightness,contrast and gain of the image can be adjusted
freely to achieve a satisfactory result. |
| Product list | Users can save the inspection parameters such as Z-axis
position,brightness,contrast and gain,and can directly call the
parameters when inspecting the same product,to improve the
inspection efficiency. |
Navigation
window | After the camera takes a photo of the table,click anywhere in the
photo,the table will move to the place you click and display on the
screen. |
| Motion axis status | Display real-time coordinates. |
| Inspection result | The measurement results(voids rate,distance, area,etc.,set by
users)display in order. |
| Speed control | The movement speed of each axis can be adjusted to slow,normal and
fast. |
Voids rate
measurement | Automatic
calculation | Click on two points to determine a rectangle.The software
automatically finds and measures the edge of the solder ball in the
rectangle,the pad and the internal voids,and can get the data of
the voids rate,the area of the solder ball,the circumference, the
biggest void's rate,the length and the width,and indicates NG or OK
by red and green. |
Parameters
adjustment | Users can adjust the grayscale threshold,pixel, contrast,size
filtering and other parameters to get accurate results of automatic
calculation. |
Add voids
manually | Users can draw a polygon or a free figure and calculate it as a
void into the void rate. |
Save
parameters | Users can save parameters such as grayscale
threshold,pixel,contrast,
size filtering and other parameters,and can directly call the
parameters when detecting the same product,to improve the detection
efficiency. |
Other
measurement
function | Distance | Click the A and B points to set as the baseline, then
click the C point to measure the vertical distance
from the C point to the baseline. |
| Distance rate | It is mostly used to measure the soldering rate of
the through-hole. Set one more point “D” than the
distance. Divide the vertical distance from the D
point to baseline by the vertical distance of the C
point, to obtain the percentage ratio of the vertical
distance of D to C. |
| Angle | Click the A and B points to set as the baseline, then
click the C point to measure the angle between the
BA and BC rays. |
| Perimeter | It is mostly used to measure square components,
click two points to determine a square, measure the
length, width and area. |
| Radius | It is mostly used to measure round components
such as solder balls. Click three points to determine
a circle and measure the circumference, area and
radius. |
Automatic
inspection | Manual setting | Users can set any positions on the table as
inspection points, the software will automatically
inspect and save the picture. |
| Array | For the regular inspection points, users only need
to set two of the inspection points and the number
of rows and columns, the software will automatically
inspect each point and save pictures. |
Automatic
identification | For inspection points with obvious features, the
software automatically identifies the positions,
takes measurements, and saves the image. |
