2 Component Thermal Conductive Silicone Potting Compound Adhesive Liquid Gel

Rtv Silicone Two Component Thermal Conductive Adhesive Waterproof Low Viscosity Waterproof Sealing High Moisture Resistance Glue

HN-8806 Two-Component Addition-Type Silicone Potting Rubber

Product Specification

Product Advantages

High-Performance Elastomer: Forms a high-elasticity, high-strength protective layer after curing.

Low Viscosity: Suitable for deep-section potting, ensuring even distribution.

No By-Products: No heat or by-products are emitted during curing, ensuring component safety.

Flame Retardant: Passes UL-94 flame retardancy tests, ensuring safety in high-temperature environments.

Eco-Friendly Certification: Complies with RoHS standards, non-polluting.

Applications

Potting and sealing of power modules, circuit boards, and high-voltage transformers.

Protection and thermal management for battery packs and fast-charging adapters.

Moisture-proof and waterproof protection for LED outdoor drive power supplies.

Other electronic components requiring vibration, water, and thermal protection.

Application Method

1.Mix components A and B in a 1:1 ratio, stir thoroughly, and then proceed with potting.

2.Ensure the surface of the components is clean before potting. For large products, pot in stages.

3.For automated production lines, vacuum components A and B separately to ensure accurate mixing ratio.

Technical Parameters

Appearance: Part A – Grey fluid; Part B – White fluid

Viscosity: 4500~5000 mPa·S

Density: 1.50±0.05 g/cm³

Mixing Ratio (A:B): 1:1

Pot Life: 0.3-0.4 hours

Curing Conditions: 4-12 hours at room temperature (initial cure), 0.2 hours at 80°C

Hardness: 50±5 Shore A

Thermal Conductivity: ≥0.76 W/m·K

Volume Resistivity: 1.0×10¹⁵ Ω·cm

Temperature Resistance: -50°C to +250°C

Packaging
10KG/Set (A 5kg + B 5kg)
20KG/Set (A 10kg + B 10kg)
50KG/Set (A 25kg + B 25kg)

Precautions

Stir components A and B separately before use to ensure even mixing.

Avoid contact with substances containing tin, sulfur, or amines to prevent curing inhibition.

Maintain cleanliness during use to prevent contamination.