48rpm Label Marking Abrasion Test Machine - 20mm Test Stroke - IEC60730-1

48rpm Label Marking Abrasion Test Machine - 20mm Test Stroke

A.1 Markings on controls shall be adequately indelible for safety and are therefore classified according to the requirements for indelibility:
A.1.1 Markings which are not mandatory within the requirements of this standard (IEC 60730-1).
A.1.2 Markings which are mandatory within the requirements of this standard but which are not accessible to the final user when the control is mounted or installed in the equipment.                            IEC Test Equipment

These markings have to be sufficiently resistant to removal to withstand the manual handling in the control manufacturer's factory after final inspection, being packed and transported to the equipment manufacturer's factory, and handled during installation. Additionally, the marking shall remain legible in the presence of any vapour or other contaminant likely to be present.                            IEC Test Equipment

Production introduction:

This testing apparatus is design and manufactured according to IEC60730-1 standard figure 8 and annex A requirements, used for testing the controller marking durability performance.              IEC Test Equipment

The apparatus comply with the dimensions requirements of IEC 60730-1 Figure 8. Test times can be set from 1 to 999999 (default as 12 times), test rate 48 rpm. It is a easy operated professional equipment.

Main technical parameters:

Picture for reference: